HSIO Single-Ended I/O Standards Specifications
HSIO Single-Ended SSTL, HSTL, HSUL, POD, and LVSTL I/O Reference Voltage Specifications
HSIO Single-Ended SSTL, HSTL, HSUL, and POD I/O Standards Signal Specifications
HSIO Single-Ended LVSTL I/O Standards Specifications
HSIO Differential SSTL, HSTL, and HSUL I/O Standards Specifications
HSIO Differential POD I/O Standards Specifications
HSIO Differential LVSTL I/O Standards Specifications
HSIO Differential I/O Standards Specifications
MIPI D-PHY I/O Standards Specifications
HPS Clock Performance
HPS Internal Oscillator Frequency
HPS PLL Specifications
HPS Cold Reset
HPS SPI Timing Characteristics
HPS SD/eMMC Timing Characteristics
HPS USB 2.0 Timing Characteristics
HPS USB 3.1 Timing Characteristics
HPS Ethernet Media Access Controller (EMAC) Timing Characteristics
HPS I2C Timing Characteristics
HPS I3C Timing Characteristics
HPS NAND Timing Characteristics
HPS Trace Timing Characteristics
HPS GPIO Interface
HPS JTAG Timing Characteristics
HPS Programmable I/O Timing Characteristics
Voltage Sensor Specifications
Parameter | Minimum | Typical | Maximum | Unit | |
---|---|---|---|---|---|
Resolution | — | 7 | — | Bit | |
Sampling rate113 | — | — | 1 | KSPS | |
Input capacitance | — | — | 40 | pF | |
External reference voltage | 1.125 | 1.25 | 1.375 | V | |
Voltage sensor accuracy, Vin range: 0 V to 1.1 V114 115 | — | — | ±3.5 | % | |
Unipolar input mode | Input signal range for Vsigp | — | — | 1.35 | V |
Common mode voltage on Vsign | — | — | 0.25 | V | |
Input signal range for Vsigp – Vsign | — | — | 1.1 | V |
113 The read out is subject to the SDM mailbox activity status.
114 For low voltage channels in channels 0, 1, 2, 6, and 7, the ±3.5% accuracy equals to ±43.75mV. For high voltage channels in channels 3, 4, 5, and 9, the accuracy is ±4.5%. This equals to ±56.25mV.
115 When Voltage Tamper Detection is enabled, the voltage sensor accuracy specifications are as follows:
- For low voltage channels in channels 0, 1, 2, 6, and 7, the accuracy is ±5.5%. This equals to ±68.75mV.
- For high voltage channels in channels 3, 4, 5, and 9, the accuracy is ±6.5%. This equals to ±81.25mV.