Visible to Intel only — GUID: xat1702342347749
Ixiasoft
1. Overview
2. Install and License the GTS Ethernet Intel® FPGA Hard IP
3. Configure and Generate Ethernet Hard IP variant
4. Integrate GTS Ethernet Intel® FPGA Hard IP into Your Application
5. Simulate, Compile, and Validate (MAC+PCS) - Single Instance
6. Simulate, Compile, and Validate (MII PCS Only /PCS66 OTN/PCS66 FlexE) - Single Instance
7. Simulate, Compile, and Validate SyncE - Single Instance
8. Simulate and Compile PTP1588 - Single Instance
9. Simulate, Compile, and Validate - Multiple Instance
10. Simulate, Compile, and Validate - Auto-Negotiation and Link Training
11. Troubleshoot and Diagnose Issues
A. Appendix A: Functional Description
B. Appendix B: Configuration Registers
C. Appendix C: Document Revision History for the GTS Ethernet Intel® FPGA Hard IP User Guide
4.1. Implement Required Clocking
4.2. Implement Required Resets
4.3. Connect the Status Interface
4.4. Connect the MAC Avalon Streaming Client Interface
4.5. Connect the MII PCS Only Client Interface
4.6. Connect the PCS66 Client Interface – FlexE and OTN
4.7. Connect the Precision Time Protocol Interface
4.8. Connect the Ethernet Hard IP Reconfiguration Interface
4.9. Connect the Auto-Negotiation and Link Training
4.1.1. Implement MAC Synchronous Clock Connections to Single Instance
4.1.2. Implement MAC Synchronous Clock Connections to Multiple Instances
4.1.3. Implement Clock Connections to MAC Asynchronous Operation
4.1.4. Implement Clock Connections in Synchronous Ethernet Operation (Sync-E)
4.1.5. Implement Clock Connections in PTP-Based Design
4.4.1.1. Drive the Ethernet Packet to the TX MAC Avalon Streaming Client Interface with Disabled Preamble Passthrough
4.4.1.2. Drive the Ethernet Packet on the TX MAC Avalon Streaming Client Interface with Enabled Preamble Passthrough
4.4.1.3. Use i_tx_skip_crc to Control Source Address, PAD, and CRC Insertion
4.4.1.4. Assert the i_tx_error to Invalidate a Packet
4.4.2.1. Receive Ethernet Frame on the RX MAC Avalon Streaming Client Interface with Preamble Passthrough Disabled
4.4.2.2. Receive Ethernet Frame with Preamble Passthrough Enabled
4.4.2.3. Receive Ethernet Frame with Remove CRC bytes Disabled
4.4.2.4. Monitor Status and Errors on the RX MAC Avalon Streaming Client Interface
Visible to Intel only — GUID: xat1702342347749
Ixiasoft
A.4.3. Make PTP UI Adjustments
This section provides steps to measure UI value to prevent time drift due to clock PPM differences as referenced to golden Time-of-Day (TOD) in the platform.
Tip: The TOD value increments constantly based on the golden TOD running at the ideal clock with 0 PPM difference. If you observe a large adjustment to the TOD value, don't perform measurement or discard any performed measurement as it impacts the measurement result.
TAM is the reference time for Alignment Marker (AM) for variants with AM, and an arbitrary selected reference bit for variants without AM.
For simulation or hardware run with 0 PPM setting, you can skip the measurement and program 0 PPM UI value as defined in the table.
Mode | 0 PPM UI value (ps) | 0 PPM UI value {4-bit ns, 28-bit fractional ns} |
---|---|---|
10GE-1 | 96.9697 | 32’h018D3019 |