Visible to Intel only — GUID: mcn1441174531054
Ixiasoft
1. Stratix® 10 Clocking and PLL Overview
2. Stratix® 10 Clocking and PLL Architecture and Features
3. Stratix® 10 Clocking and PLL Design Considerations
4. Stratix® 10 Clocking and PLL Implementation Guides
5. Clock Control Intel® FPGA IP Core References
6. IOPLL Intel® FPGA IP Core References
7. IOPLL Reconfig Intel® FPGA IP Core References
8. Stratix® 10 Clocking and PLL User Guide Archives
9. Document Revision History for the Stratix® 10 Clocking and PLL User Guide
2.2.1. PLL Features
2.2.2. PLL Usage
2.2.3. PLL Architecture
2.2.4. PLL Control Signals
2.2.5. Clock Feedback Modes
2.2.6. Clock Multiplication and Division
2.2.7. Programmable Phase Shift
2.2.8. Programmable Duty Cycle
2.2.9. PLL Cascading
2.2.10. Clock Switchover
2.2.11. PLL Reconfiguration and Dynamic Phase Shift
2.2.12. PLL Calibration
4.3.4.1. Design Example 1: .mif Streaming Reconfiguration Using IOPLL Reconfig IP Core
4.3.4.2. Design Example 2: Advanced Mode Reconfiguration Using IOPLL Reconfig IP Core
4.3.4.3. Design Example 3: Clock Gating Reconfiguration Using IOPLL Reconfig IP Core
4.3.4.4. Design Example 4: Dynamic Phase Shift Using IOPLL Reconfig IP Core
Visible to Intel only — GUID: mcn1441174531054
Ixiasoft
2.2.12.2. User Calibration
The I/O PLL must be recalibrated for any of the following conditions after device power up:
- Dynamic I/O PLL reconfiguration that changes the M or N counter settings is performed.
- Change of the reference clock frequency to the I/O PLL.
Recalibration is not necessary when using clock switchover to a secondary reference clock with a different frequency than the primary reference clock. The I/O PLL stores the calibration settings for both reference clocks after power-up calibration.
To perform the recalibration of the I/O PLL, you must enable the IOPLL Reconfig Intel® FPGA IP core to enable the recalibration mode.