Visible to Intel only — GUID: kid1520581446868
Ixiasoft
1. Stratix® 10 Clocking and PLL Overview
2. Stratix® 10 Clocking and PLL Architecture and Features
3. Stratix® 10 Clocking and PLL Design Considerations
4. Stratix® 10 Clocking and PLL Implementation Guides
5. Clock Control Intel® FPGA IP Core References
6. IOPLL Intel® FPGA IP Core References
7. IOPLL Reconfig Intel® FPGA IP Core References
8. Stratix® 10 Clocking and PLL User Guide Archives
9. Document Revision History for the Stratix® 10 Clocking and PLL User Guide
2.2.1. PLL Features
2.2.2. PLL Usage
2.2.3. PLL Architecture
2.2.4. PLL Control Signals
2.2.5. Clock Feedback Modes
2.2.6. Clock Multiplication and Division
2.2.7. Programmable Phase Shift
2.2.8. Programmable Duty Cycle
2.2.9. PLL Cascading
2.2.10. Clock Switchover
2.2.11. PLL Reconfiguration and Dynamic Phase Shift
2.2.12. PLL Calibration
4.3.4.1. Design Example 1: .mif Streaming Reconfiguration Using IOPLL Reconfig IP Core
4.3.4.2. Design Example 2: Advanced Mode Reconfiguration Using IOPLL Reconfig IP Core
4.3.4.3. Design Example 3: Clock Gating Reconfiguration Using IOPLL Reconfig IP Core
4.3.4.4. Design Example 4: Dynamic Phase Shift Using IOPLL Reconfig IP Core
Visible to Intel only — GUID: kid1520581446868
Ixiasoft
4.3.3.2.1. Recalibration Using Advanced Mode
To perform I/O PLL recalibration using advanced mode, follow these steps:
- Set mgmt_address[9:8] = 2’b01 to choose the advanced mode.
- Set the mgmt_writedata[6] to 1’b1 on mgmt_address[7:0] = 8’b01001001 by performing the read-modify-write operation.
- Set mgmt_address[7:0] = 8’b01001010 and mgmt_wriredata[7:0] = 8’b00000011 to enable the calibration interface.