Visible to Intel only — GUID: mcn1461662667317
Ixiasoft
1. Stratix® 10 Clocking and PLL Overview
2. Stratix® 10 Clocking and PLL Architecture and Features
3. Stratix® 10 Clocking and PLL Design Considerations
4. Stratix® 10 Clocking and PLL Implementation Guides
5. Clock Control Intel® FPGA IP Core References
6. IOPLL Intel® FPGA IP Core References
7. IOPLL Reconfig Intel® FPGA IP Core References
8. Stratix® 10 Clocking and PLL User Guide Archives
9. Document Revision History for the Stratix® 10 Clocking and PLL User Guide
2.2.1. PLL Features
2.2.2. PLL Usage
2.2.3. PLL Architecture
2.2.4. PLL Control Signals
2.2.5. Clock Feedback Modes
2.2.6. Clock Multiplication and Division
2.2.7. Programmable Phase Shift
2.2.8. Programmable Duty Cycle
2.2.9. PLL Cascading
2.2.10. Clock Switchover
2.2.11. PLL Reconfiguration and Dynamic Phase Shift
2.2.12. PLL Calibration
4.3.4.1. Design Example 1: .mif Streaming Reconfiguration Using IOPLL Reconfig IP Core
4.3.4.2. Design Example 2: Advanced Mode Reconfiguration Using IOPLL Reconfig IP Core
4.3.4.3. Design Example 3: Clock Gating Reconfiguration Using IOPLL Reconfig IP Core
4.3.4.4. Design Example 4: Dynamic Phase Shift Using IOPLL Reconfig IP Core
Visible to Intel only — GUID: mcn1461662667317
Ixiasoft
2.2.5.4. Normal Compensation Mode
An internal clock in normal compensation mode is phase-aligned to the input clock pin. The external clock output pin has a phase delay relative to the clock input pin if connected in this mode. The Quartus® Prime Timing Analyzer reports any phase difference between the two. In normal compensation mode, the delay introduced by the clock network is fully compensated. Only one output clock can be compensated in normal compensation mode.
Figure 13. Example of Phase Relationship Between the PLL Clocks in Normal Compensation Mode