Visible to Intel only — GUID: apa1488864607497
Ixiasoft
1. Stratix® 10 Clocking and PLL Overview
2. Stratix® 10 Clocking and PLL Architecture and Features
3. Stratix® 10 Clocking and PLL Design Considerations
4. Stratix® 10 Clocking and PLL Implementation Guides
5. Clock Control Intel® FPGA IP Core References
6. IOPLL Intel® FPGA IP Core References
7. IOPLL Reconfig Intel® FPGA IP Core References
8. Stratix® 10 Clocking and PLL User Guide Archives
9. Document Revision History for the Stratix® 10 Clocking and PLL User Guide
2.2.1. PLL Features
2.2.2. PLL Usage
2.2.3. PLL Architecture
2.2.4. PLL Control Signals
2.2.5. Clock Feedback Modes
2.2.6. Clock Multiplication and Division
2.2.7. Programmable Phase Shift
2.2.8. Programmable Duty Cycle
2.2.9. PLL Cascading
2.2.10. Clock Switchover
2.2.11. PLL Reconfiguration and Dynamic Phase Shift
2.2.12. PLL Calibration
4.3.4.1. Design Example 1: .mif Streaming Reconfiguration Using IOPLL Reconfig IP Core
4.3.4.2. Design Example 2: Advanced Mode Reconfiguration Using IOPLL Reconfig IP Core
4.3.4.3. Design Example 3: Clock Gating Reconfiguration Using IOPLL Reconfig IP Core
4.3.4.4. Design Example 4: Dynamic Phase Shift Using IOPLL Reconfig IP Core
Visible to Intel only — GUID: apa1488864607497
Ixiasoft
3.3. Guideline: Resetting the PLL
To reset the PLL, refer to the following guidelines:
- When changing the M counter, N counter, or loop filter settings, the I/O PLL may lose and regain lock. To maintain the appropriate phase relationship between the reference clock and output clocks, assert the areset signal to reset the I/O PLL after reconfiguration is complete. Intel recommends always resetting the I/O PLL after any reconfiguration operation to the M counter, N counter, or loop filter settings.
- When changing the C counter settings, you may lose the expected phase relationship between the C counters. Assert the areset signal after reconfiguration is complete to restore the expected phase relationship. Reset is not required if the phase relationships are not important to your application.
- Resetting the I/O PLL does not modify the counter or loop filter settings. However, resetting the I/O PLL undoes any dynamic phase shift operations that were performed. After the I/O PLL is reset, the phase shift on the C counters is restored to the originally programmed settings.