Visible to Intel only — GUID: gnu1683856366366
Ixiasoft
1. About Triple-Speed Ethernet Intel® FPGA IP for Agilex™ 5 devices
2. Getting Started
3. Parameter Settings
4. Functional Description
5. Configuration Register Space
6. Interface Signals
7. Design Considerations
8. Timing Constraints
9. Testbench
10. Triple-Speed Ethernet Intel® FPGA IP User Guide Archives
11. Document Revision History for the Triple-Speed Ethernet Intel® FPGA IP User Guide: Agilex™ 5 FPGAs and SoCs
A. Ethernet Frame Format
B. Simulation Parameters
4.1.1. MAC Architecture
4.1.2. MAC Interfaces
4.1.3. MAC Transmit Datapath
4.1.4. MAC Receive Datapath
4.1.5. MAC Transmit and Receive Latencies
4.1.6. FIFO Buffer Thresholds
4.1.7. Congestion and Flow Control
4.1.8. Magic Packets
4.1.9. MAC Local Loopback
4.1.10. MAC Reset
4.1.11. PHY Management (MDIO)
4.1.12. Connecting MAC to External PHYs
6.1.1. 10/100/1000 Ethernet MAC Signals
6.1.2. 10/100/1000 Multiport Ethernet MAC Signals
6.1.3. 10/100/1000 Ethernet MAC with 1000BASE-X/SGMII PCS Signals
6.1.4. 10/100/1000 Ethernet MAC with Internal FIFO Buffers, and 1000BASE-X/SGMII 2XTBI PCS with Embedded PMA (GTS) Signals
6.1.5. 10/100/1000 Multiport Ethernet MAC with 1000BASE-X/SGMII PCS Signals
6.1.6. 1000BASE-X/SGMII PCS Signals
6.1.7. 1000BASE-X/SGMII 2XTBI PCS Signals
6.1.1.1. Clock and Reset Signals
6.1.1.2. Clock Enabler Signals
6.1.1.3. MAC Control Interface Signals
6.1.1.4. MAC Status Signals
6.1.1.5. MAC Receive Interface Signals
6.1.1.6. MAC Transmit Interface Signals
6.1.1.7. Pause and Magic Packet Signals
6.1.1.8. MII/GMII/RGMII Signals
6.1.1.9. PHY Management Signals
Visible to Intel only — GUID: gnu1683856366366
Ixiasoft
4.2.9. 1000BASE-X/SGMII PCS Reset
A hardware reset resets all logic synchronized to the respective clock domains whereas a software reset only resets the PCS state machines, comma detection function, and 8B10B encoder and decoder. To trigger a hardware reset on the PCS only variants, assert the respective reset signals: reset_reg_clk, reset_tx_clk, and reset_rx_clk. To trigger a software reset, set the RESET bit in the control register to 1. Assert the reset signals to perform a hardware reset on MAC with 2XTBI PCS and embedded PMA (GTS) variation.
Note: You must assert the reset signal for at least three clock cycles.
Figure 32. Reset Requirement in MAC with 2XTBI PCS and Embedded PMA (GTS)
- No specific reset sequence or initialization is needed for this variant.
- phyip_reset_tx_in signal must be asserted till phyip_reset_tx_ack_o is asserted.
- phyip_reset_rx_in signal must be asserted till phyip_reset_rx_ask_o is asserted.