Visible to Intel only — GUID: ohh1485341718186
Ixiasoft
Visible to Intel only — GUID: ohh1485341718186
Ixiasoft
6.5.1.1. Configuration Images
Each Intel® Cyclone® 10 LP device in your system requires one factory image.
The factory image is a user-defined configuration image that contains logic to perform the following:
- Process errors based on the status provided by the dedicated remote system upgrade circuitry.
- Communicate with the remote host, receives new application images, and stores the images in the local non-volatile memory device.
- Determine the application image to load into the Intel® Cyclone® 10 LP device.
- Enable or disable the user watchdog timer and loads its time-out value.
- Instruct the dedicated remote system upgrade circuitry to start a reconfiguration cycle.
In AS configuration scheme, when an Intel® Cyclone® 10 LP is first powered, it loads the factory configuration located at address boot_address[23:0] = 24b'0. Intel recommends that you store the factory configuration image for your system at boot address 24b'0, which corresponds to the start address location 0×000000 in the serial configuration device. A factory configuration image is a bitstream for the Intel® Cyclone® 10 LP device in your system that is programmed during production and is the fall-back image when an error occurs. This image is stored in non-volatile memory and is never updated or modified using remote access.