Visible to Intel only — GUID: fpb1559098033858
Ixiasoft
1. HDMI Intel® FPGA IP Design Example Quick Start Guide for Intel® Arria® 10 Devices
2. HDMI 2.1 Design Example (Support FRL = 1)
3. HDMI 2.0 Design Example (Support FRL = 0)
4. HDCP Over HDMI 2.0/2.1 Design Example
5. HDMI Intel® Arria® 10 FPGA IP Design Example User Guide Archives
6. Revision History for HDMI Intel® Arria® 10 FPGA IP Design Example User Guide
2.1. HDMI 2.1 RX-TX Retransmit Design Block Diagram
2.2. Creating RX-Only or TX-Only Designs
2.3. Hardware and Software Requirements
2.4. Directory Structure
2.5. Design Components
2.6. Dynamic Range and Mastering (HDR) InfoFrame Insertion and Filtering
2.7. Design Software Flow
2.8. Running the Design in Different FRL Rates
2.9. Clocking Scheme
2.10. Interface Signals
2.11. Design RTL Parameters
2.12. Hardware Setup
2.13. Simulation Testbench
2.14. Design Limitations
2.15. Debugging Features
2.16. Upgrading Your Design
3.1. HDMI 2.0 RX-TX Retransmit Design Block Diagram
3.2. Hardware and Software Requirements
3.3. Directory Structure
3.4. Design Components
3.5. Dynamic Range and Mastering (HDR) InfoFrame Insertion and Filtering
3.6. Clocking Scheme
3.7. Interface Signals
3.8. Design RTL Parameters
3.9. Hardware Setup
3.10. Simulation Testbench
3.11. Upgrading Your Design
Visible to Intel only — GUID: fpb1559098033858
Ixiasoft
4.3.1. Set Up the Hardware
The first stage of the demonstration is to set up the hardware.
When SUPPORT FRL = 0, follow these steps to set up the hardware for the demonstration:
- Connect the Bitec HDMI 2.0 FMC daughter card (revision 11) to the Arria 10 GX development kit at FMC port B.
- Connect the Arria 10 GX development kit to your PC using a USB cable.
- Connect an HDMI cable from the HDMI RX connector on the Bitec HDMI 2.0 FMC daughter card to an HDCP-enabled HDMI device, such as a graphic card with HDMI output.
- Connect another HDMI cable from the HDMI TX connector on the Bitec HDMI 2.0 FMC daughter card to an HDCP-enabled HDMI device, such as a television with HDMI input.
When SUPPORT FRL = 1, follow these steps to set up the hardware for the demonstration:
- Connect the Bitec HDMI 2.1 FMC daughter card (revision 4 or 4a) to the Arria 10 GX development kit at FMC port B.
- Connect the Arria 10 GX development kit to your PC using a USB cable.
- Connect an HDMI 2.1 Category 3 cables from HDMI RX connector on the Bitec HDMI 2.1 FMC daughter card to an HDCP-enabled HDMI 2.1 source, such as Quantum Data 980 48G Generator.
- Connect another HDMI 2.1 Category 3 cables from the HDMI TX connector on the Bitec HDMI 2.1 FMC daughter card to an HDCP-enabled HDMI 2.1 sink, such as Quantum Data 980 48G Analyzer.