Visible to Intel only — GUID: dww1686335419448
Ixiasoft
1. Introduction to the Agilex™ 5 Hard Processor System Component
2. Configuring the Agilex™ 5 Hard Processor System Component
3. Simulating the Agilex™ 5 HPS Component
4. Design Guidelines
5. HPS EMIF Platform Designer Example Designs
6. Document Revision History for the Hard Processor System Component Reference Manual Agilex™ 5 SoCs
2.1. Parameterizing the HPS Component
2.2. HPS-FPGA Interfaces
2.3. SDRAM
2.4. HPS Clocks, Reset, Power
2.5. I/O Delays
2.6. Pin Mux and Peripherals
2.7. Generating and Compiling the HPS Component
2.8. Using the Address Span Extender Component
2.9. Configuring the Agilex™ 5 Hard Processor System Component Revision History
2.2.1.1. Enable MPU Standby and Event Signals
2.2.1.2. Enable General Purpose Signals
2.2.1.3. Enable Debug APB* Interface
2.2.1.4. Enable System Trace Macrocell (STM) Hardware Events
2.2.1.5. Enable SWJ-DP JTAG Interface
2.2.1.6. Enable FPGA Cross Trigger Interface
2.2.1.7. Enable AMBA* Trace Bus (ATB)
3.1. Simulation Flows
3.2. Running the Simulation of the Design Examples
3.3. Clock and Reset Interface
3.4. FPGA-to-HPS AXI* Subordinate Interface
3.5. FPGA-to-SDRAM AXI* Subordinate Interface
3.6. HPS-to-FPGA AXI* Initiator Interface
3.7. Lightweight HPS-to-FPGA AXI* Initiator Interface
3.8. Simulating the Agilex™ 5 HPS Component Revision History
5.1. Terminology
5.2. Block Diagram
5.3. Version Support
5.4. Download Example Design Files
5.5. HPS EMIF Platform Designer Example Designs
5.6. Specific Examples
5.7. General Connection Guideline
5.8. Supported Memory Protocols Differences Among Intel SoC Device Families
5.9. IO96 Bank and Lane Usage for HPS EMIF
5.10. Quartus Report of I/O Bank Usage
Visible to Intel only — GUID: dww1686335419448
Ixiasoft
3.1.2. Generating the HPS Simulation Model in Platform Designer
Note: This section describes how to generate the simulation model when a single .qsys system is in the Quartus® Prime project. It does not describe the method to generate the simulation model when multiple .qsys systems are in the Quartus® Prime project. There are plans to describe this in a future version of this document.
The following steps outline how to generate the simulation model:
- In Quartus® Prime Pro Edition software, launch the Platform Designer and open your system design that has been created in the previous section.
- In Platform Designer, click on the Generate HDL button.
Figure 32. Platform Designer - Generate HDL... button
- In the Simulation section, use the “Create simulation model” dropdown list to choose “Verilog” or “VHDL”.
- Select which of the supported simulators to generate files. (Leaving all the boxes unselected generates files for all simulators.)
- Click on Generate button.
Figure 33. Platform Designer - Select Simulators to Generate