Cyclone® 10 GX FPGA Development Kit User Guide

Download PDF
ID 683696
Date 8/09/2024
Public
Document Table of Contents
Document Table of Contents x
1. Overview 2. Getting Started 3. Development Kit Setup 4. Board Test System 5. Document Revision History for the Cyclone® 10 GX FPGA Development Kit User Guide A. Development Kit Components B. Additional Information
1. Overview x
1.1. Block Diagram 1.2. Feature Summary 1.3. Box Contents 1.4. Recommended Operating Conditions
2. Getting Started x
2.1. Quartus® Prime Software and Driver Installation 2.2. Development Kit Package
3. Development Kit Setup x
3.1. Setting up the Development Kit 3.2. Default Switch and Jumper Settings
4. Board Test System x
4.1. Preparing the Board 4.2. Running the Board Test System 4.3. Using the Board Test System
4.3. Using the Board Test System x
4.3.1. The Configure Menu 4.3.2. The System Info Tab 4.3.3. The GPIO Tab 4.3.4. The EPCQ Tab 4.3.5. The XCVR Tab 4.3.6. The FMC Tab 4.3.7. The DDR3 Tab 4.3.8. Power Monitor 4.3.9. Clock Controller
A. Development Kit Components x
A.1. Board Overview A.2. Cyclone® 10 GX FPGA A.3. MAX 10 System Controller A.4. FPGA Configuration A.5. Status and User I/O Elements A.6. Clocks A.7. Memory A.8. Power A.9. Transceivers Interfaces and Communication Ports
A.5. Status and User I/O Elements x
A.5.1. Switches A.5.2. Pushbuttons A.5.3. LEDs
A.7. Memory x
A.7.1. EMIF with DDR3 A.7.2. QSPI Flash
A.9. Transceivers Interfaces and Communication Ports x
A.9.1. Transceiver Channels A.9.2. PCIe Interface A.9.3. SFP+ Interface A.9.4. USB3.1 Type-C Interface A.9.5. FPGA Mezzanine Card (FMC) Interface A.9.6. 10/100/1000Base-T Ethernet Connector A.9.7. I2C/PMBUS
B. Additional Information x
B.1. Safety and Regulatory Information B.2. Compliance and Conformity Statements
B.1. Safety and Regulatory Information x
B.1.1. Safety Warnings B.1.2. Safety Cautions
1. Overview
2. Getting Started
3. Development Kit Setup
4. Board Test System
5. Document Revision History for the Cyclone® 10 GX FPGA Development Kit User Guide
A. Development Kit Components
B. Additional Information

A.5.2. Pushbuttons

The push buttons are located on the upper right corner of the board.

Table 16.  Push Button Definition
Board Reference Signal Name Function
S11 USER_PB2 User available Pushbutton 2
S10 USER_PB1 User available Pushbutton 1
S8 USER_PB0 User available Pushbutton 0
S7 PGM_SEL PFL Image selection. Use this pushbutton to rotate through three images.
S12 SYS_CONFIG_PB Trigger reconfiguration to Cyclone® 10 GX FPGA. The image used for configuration is selected with PGM_SEL button and indicated by PGM_NUM LEDs.
S13 C10_RESETn_PB Trigger logic reset to Cyclone® 10 GX FPGA logic. The state of the configured logic is reset, the configuration remains unchanged.
Level Two Title