AN 701: Scalable Low Latency Ethernet 10G MAC using Intel Arria 10 1G/10G PHY

Download PDF
ID 683343
Date 11/06/2017
Public
Document Table of Contents
Document Table of Contents x
Scalable Low Latency Ethernet 10G MAC using Intel Arria 10 1G/10G PHY
Scalable Low Latency Ethernet 10G MAC using Intel Arria 10 1G/10G PHY x
Features Requirements Design Example Walkthrough Components Parameters Design Example Testbench Clocking Scheme Reset Scheme Interface Signals Register Map Document Revision History for Scalable Low Latency Ethernet 10G MAC using Intel Arria 10 1G/10G PHY
Design Example Walkthrough x
Setting Up the Design Examples Changing Number of Channels Configuring PHY Speed IP Regeneration
Configuring PHY Speed x
Changing Speed between 10G and 1G in 1000BaseX mode Changing Speed between 1G, 100M, and 10M SGMII
Design Example Testbench x
Testbench Components Testbench Files Simulating Testbench Test Case
Simulating Testbench x
Using ModelSim Simulator Using VCS Simulator
Test Case x
Test Scenario for Design Example without IEEE 1588v2 Test Scenario for Design Example with IEEE 1588v2
Clocking Scheme x
Clocking Diagram Sync-E Support
Sync-E Support x
Enable Ref Clock Sharing Disable Ref Clock Sharing
Reset Scheme x
Design Example without IEEE 1588v2 Design Example with IEEE 1588v2
Design Example without IEEE 1588v2 x
Multi Channel Level Reset Scheme Channel Level Reset Scheme
Design Example with IEEE 1588v2 x
Multi Channel Level Reset Scheme Channel Level Reset Scheme
Interface Signals x
Clock and Reset Interface Signals Avalon-MM Interface Signals Avalon-ST Interface Signals PHY Interface Signals MDIO Interface Signals IEEE 1588v2 Timestamp Interface Signals Packet Classifier Interface Signals ToD Interface Signals
Register Map x
Master TOD 1G TOD 10G TOD PHY 1G/10G MAC
Scalable Low Latency Ethernet 10G MAC using Intel Arria 10 1G/10G PHY

Channel Level Reset Scheme

The following diagram shows the reset scheme per channel. mm_reset is used to reset the registers in MAC, PHY, MDIO and address_decoder block while datapath_reset is used to reset all digital blocks including PHY reset controller. However, mm_reset and datapath_reset are tied together at multi channel level in the design example, therefore they can't be triggered separately.

Reset scheme at altera_eth_channel


Level Two Title