Visible to Intel only — GUID: gkq1683045151554
Ixiasoft
1. About This Document
2. Agilex™ 5 E-Series Intel® Simics® Virtual Platforms
3. Agilex™ 5 E-Series Virtual Platform Component Intel® Simics® Models
4. Running a Simulation with the Agilex™ 5 E-Series HPS Model
5. Supported Use Cases
6. Troubleshooting Issues When Migrating Software from Intel® Simics® to Hardware
A. Document Revision History
2.1.3.1. Boot-To-Operating System Prompt
2.1.3.2. Basic Ethernet
2.1.3.3. CPU Power-On and Boot Core Selection
2.1.3.4. Reset Flow
2.1.3.5. General Purpose I/O (GPIO) Loopback
2.1.3.6. USB Disks Hot-Plug Support
2.1.3.7. On-Chip Memory IP FPGA Fabric Example Design
2.1.3.8. FPGA-to-HPS Bridges
2.1.3.9. Exercising Peripheral Subsystem in FPGA Fabric Design
2.1.3.10. USB Controller Host/Device Mode Configuration
2.1.3.11. B0 Silicon Features Selection
Visible to Intel only — GUID: gkq1683045151554
Ixiasoft
4. Running a Simulation with the Agilex™ 5 E-Series HPS Model
This section describes how to start running an Intel® Simics® simulation for the Agilex™ 5 E-Series HPS Intel® Simics® Model using the Agilex™ 5 E-Series Universal Virtual Platform. The instructions in this section exercise the boot flow from U-Boot FSBL to a Linux prompt booting from an SD card flash device.
For information about exercising other use cases, refer to Supported Use Cases.