Visible to Intel only — GUID: sam1412833569968
Ixiasoft
1. Agilex™ 7 M-Series LVDS SERDES Overview
2. Agilex™ 7 M-Series LVDS SERDES Architecture
3. Agilex™ 7 M-Series LVDS SERDES Transmitter
4. Agilex™ 7 M-Series LVDS SERDES Receiver
5. Agilex™ 7 M-Series High-Speed LVDS I/O Implementation Guide
6. Agilex™ 7 M-Series LVDS SERDES Timing
7. LVDS SERDES Intel® FPGA IP Design Examples
8. Agilex™ 7 M-Series LVDS SERDES Design Guidelines
9. Agilex™ 7 M-Series LVDS SERDES Troubleshooting Guidelines
10. Documentation Related to the Agilex™ 7 LVDS SERDES User Guide: M-Series
11. Document Revision History for the Agilex™ 7 LVDS SERDES User Guide: M-Series
5.1.6.1. LVDS SERDES Intel® FPGA IP General Settings
5.1.6.2. LVDS SERDES Intel® FPGA IP Pin Settings
5.1.6.3. LVDS SERDES Intel® FPGA IP PLL Settings
5.1.6.4. LVDS SERDES Intel® FPGA IP Receiver Settings
5.1.6.5. LVDS SERDES Intel® FPGA IP Transmitter Settings
5.1.6.6. LVDS SERDES Intel® FPGA IP Clock Resource Summary
8.1. Use PLLs in Integer PLL Mode for LVDS SERDES
8.2. Use High-Speed Clock from PLL to Clock SERDES Only
8.3. Pin Placement for Differential Channels
8.4. SERDES Pin Pairs for Soft-CDR Mode
8.5. Placing LVDS SERDES Transmitters and Receivers in the Same GPIO-B Sub-Bank with External PLL
8.6. Sharing LVDS SERDES I/O Lane with Other Intel® FPGA IPs
8.7. VCCIO_PIO Power Scheme for LVDS SERDES
Visible to Intel only — GUID: sam1412833569968
Ixiasoft
5.3.3. Resetting the DPA
If data corruption occurs, reset the DPA circuitry.
- Assert the rx_dpa_reset signal to reset the entire DPA block. After you reset the entire DPA block, the DPA must be retrained before capturing data.
You can also fix data corruption by resetting only the synchronization FIFO without resetting the DPA circuit, which means that system operation continues without having to retrain the DPA. To reset just the synchronization FIFO, assert the rx_fifo_reset signal.
- After rx_dpa_locked asserts, the LVDS SERDES IP is ready to capture data. The DPA finds the optimal sample location to capture each bit.
Altera recommends that you toggle the rx_fifo_reset signal after rx_dpa_locked asserts. Toggling rx_fifo_reset ensures that the synchronization FIFO is set with the optimal timing to transfer data between the DPA and the high-speed LVDS SERDES clock domains.
- Using custom logic to control the rx_bitslip_ctrl signal on a channel-by-channel basis, set up the word boundary.
You can reset the bit slip circuit at any time, independent of the PLL or DPA circuit operation. To reset the bit slip circuit, use the rx_bitslip_reset signal.