Visible to Intel only — GUID: bhc1417759240203
Ixiasoft
1. About the F-Tile Low Latency Ethernet 10G MAC Intel® FPGA IP User Guide
2. Low Latency Ethernet 10G MAC Intel® FPGA IP Overview
3. Getting Started
4. Functional Description
5. Low Latency Ethernet 10G MAC Intel® FPGA IP Parameters
6. Interface Signals
7. Configuration Registers
8. F-Tile Low Latency Ethernet 10G MAC Intel FPGA IP User Guide Archives
9. Document Revision History for the F-Tile Low Latency Ethernet 10G MAC Intel® FPGA IP User Guide
3.1. Introduction to Intel® FPGA IP Cores
3.2. Installing and Licensing Intel® FPGA IP Cores
3.3. Specifying the IP Core Parameters and Options ( Quartus® Prime Pro Edition)
3.4. Generated File Structure
3.5. Simulating Intel® FPGA IP Cores
3.6. Upgrading the Low Latency Ethernet 10G MAC Intel® FPGA IP Core
3.7. Low Latency Ethernet 10G MAC Intel® FPGA IP Design Examples
6.1. Clock and Reset Signals
6.2. Speed Selection Signal
6.3. Error Correction Signals
6.4. Avalon® Memory-Mapped Interface Programming Signals
6.5. Avalon® Streaming Data Interfaces
6.6. Avalon® Streaming Flow Control Signals
6.7. Avalon® Streaming Status Interface
6.8. PHY-side Interfaces
6.9. IEEE 1588v2 Interfaces
Visible to Intel only — GUID: bhc1417759240203
Ixiasoft
3.6.1.1.3. Dual Clock FIFO
The bit skew of the dual clock FIFO gray-coded pointers must be within one 312.5 MHz clock period.
The timing constraint file uses the set_net_delay to constraint the fitter placement and set_max_skew to perform timing check on the paths. For a project with very high device utilization, Intel recommends that you implement addition steps like floor planning or Logic Lock to aid the place-and-route process. The additional steps can give a more consistent timing closure along these paths instead of only relying on the set_net_delay.