MIPI CSI-2 Intel® FPGA IP User Guide

ID 813926
Date 7/23/2024
Public

A newer version of this document is available. Customers should click here to go to the newest version.

Document Table of Contents

4.3.2. MIPI CSI-2 Receiver Clock Requirements

The MIPI CSI-2 receiver axi4_clk frequency must ensure that the output video data rate is the same or greater than the peak burst data rate on the external MIPI D-PHY interface. If not, data loss occurs.
Equation 4. Derivation of the CSI-2 Receiver axi4_clk Minimum Rate

Altera recommends that you allow at least 10% buffer above the minimum clock rate calculated for this clock.

Table 20.  MIPI CSI-2 Receiver AXI4-Stream Video Clock (axi4s_clk) Examples
Video Data Type Lane Rate (Mbps) PPI Bus Width (Bits) rx_word_clk_hs_dX (MHz) Lanes Pixels in Parallel Bits per Pixel axi4s_clk (MHz)
RAW10 800 16 50 2 1 10 >160
RAW16 2500 16 156.25 4 4 16 >160
RGB888 1500 16 93.75 4 2 24 >125
YUV422 8-bit 1000 16 62.5 8 2 16 >250