Serial Lite III Streaming Stratix® 10 FPGA IP Design Example User Guide

ID 683341
Date 5/23/2024
Public
Document Table of Contents

4.6. Signals

Figure 39. Top-level Signals for Stratix® 10 E-tile Serial Lite III Streaming Standard Clocking Mode Design Example
Table 13.  Design Example Interface Signals
Signal Direction Width Description
Clock and Reset Signal
mgmt_clk Input 1
Input clock for:
  • Avalon® memory-mapped PHY management interface for Serial Lite III Streaming IP core
  • Demo management module
  • Demo control module
  • Transceiver reset controller
pll_ref_clk Input 1

This reference clock is used by the Clock Data Recovery (CDR) unit in the transceiver. It serves as a reference for the CDR to recover the clock from the serial line. The frequency of this clock must match the frequency you select in the IP parameter editor.

iopll_ref_clk Input 1 This clock is used as a reference clock for the IOPLL user clock.
mgmt_reset_n Input 1

Design example asynchronous master reset. Assert this reset signal to reset the overall design example system.

This is an active low signal.

snk_core_reset_n Output 1

Demo management module asserts this signal to reset traffic checker module.

src_core_reset_n Output 1

Demo management module asserts this signal to reset traffic generator module.

Data Signal
rx[n] Input Based on Number of Lanes value

This vector carries the transmitted streaming data from the core.

n represents the number of lanes.

tx[n] Output Based on Number of Lanes value

This vector carries the transmitted streaming data to the core.

n represents the number of lanes.

Status Signal
rx_activity_n Output 1

This single bit signal indicates that the data is valid.

tx_activity_n Output 1

This single bit signal indicates that the data is valid.

snk_link_up_n Output 1

The core asserts this signal to indicate that the core initialization is complete and is ready to receive user data.

src_link_up_n Output 1

The core asserts this signal to indicate that the core initialization is complete and is ready to transmit user data.