MIPI CSI-2 Intel® FPGA IP Design Example User Guide

Download PDF
ID 813931
Date 4/26/2024
Public
Document Table of Contents
Document Table of Contents x
1. MIPI CSI-2 Intel® FPGA IP Design Example Quick Start Guide 2. MIPI CSI-2 Intel® FPGA IP Design Example 3. Document Revision History for the MIPI CSI-2 Intel® FPGA IP Design Example User Guide
1. MIPI CSI-2 Intel® FPGA IP Design Example Quick Start Guide x
1.1. Generating the Design 1.2. Simulating the Design 1.3. Directory Structure 1.4. Compiling the Design
1.1. Generating the Design x
1.1.1. Design Example Parameters
2. MIPI CSI-2 Intel® FPGA IP Design Example x
2.1. Agilex™ 5 MIPI CSI-2 RX+TX Subsystem Design Features 2.2. Agilex™ 5 MIPI CSI-2 RX-only Design Features 2.3. Software Requirements 2.4. Functional Description 2.5. Simulation
2.4. Functional Description x
2.4.1. Design Components 2.4.2. Reset Scheme 2.4.3. Clocking Scheme
2.5. Simulation x
2.5.1. Data Signal Checking 2.5.2. Verification 2.5.3. Display Messages 2.5.4. Waveform Plotting 2.5.5. Structure 2.5.6. Known Limitations
2.5.5. Structure x
2.5.5.1. Top Level Testbench 2.5.5.2. Device Under Test (DUT) Wrapper 2.5.5.3. PHY-Protocol Interface (PPI) Loopback 2.5.5.4. Test Generator
1. MIPI CSI-2 Intel® FPGA IP Design Example Quick Start Guide
2. MIPI CSI-2 Intel® FPGA IP Design Example
3. Document Revision History for the MIPI CSI-2 Intel® FPGA IP Design Example User Guide

2.5.4. Waveform Plotting

The simulation allows plotting waveforms for graphical analysis.

To use GUI mode for Mentor modelsim or questasim, Intel recommends that you open the simulator GUI and run “source sim_GUI.do”. You can then add the signals you wish to plot before running the simulation.

To use GUI mode for Synopsys VCS or VCSMX, first run “source sim.sh” as you would for command line execution. Then, type “./simv -gui” to open the simulator GUI. You can then add the signals you wish to plot before running the simulation.

Level Two Title