Visible to Intel only — GUID: lym1691672124682
Ixiasoft
1. Agilex™ 7 FPGA M-Series Clocking and PLL Overview
2. M-Series Clocking and PLL Architecture and Features
3. M-Series Clocking and PLL Design Considerations
4. Clock Control Intel® FPGA IP Core
5. IOPLL Intel® FPGA IP Core
6. I/O PLL Reconfiguration Using EMIF Calibration IP
7. Agilex™ 7 Clocking and PLL User Guide: M-Series Archives
8. Document Revision History for the Agilex™ 7 Clocking and PLL User Guide: M-Series
2.2.1. PLL Features
2.2.2. PLL Usage
2.2.3. PLL Locations
2.2.4. PLL Architecture
2.2.5. PLL Control Signals
2.2.6. PLL Feedback Modes
2.2.7. Clock Multiplication and Division
2.2.8. Programmable Phase Shift
2.2.9. Programmable Duty Cycle
2.2.10. PLL Cascading
2.2.11. PLL Input Clock Switchover
2.2.12. PLL Reconfiguration and Dynamic Phase Shift
2.2.13. PLL Calibration
3.1. Guidelines: Clock Switchover
3.2. Guidelines: Timing Closure
3.3. Guidelines: Resetting the PLL
3.4. Guidelines: Configuration Constraints
3.5. Clocking Constraints
3.6. IP Core Constraints
3.7. Guideline: Achieving 5% Duty Cycle for fOUT_EXT ≥ 300 MHz Using tx_outclk Port from LVDS SERDES Intel® FPGA IP
Visible to Intel only — GUID: lym1691672124682
Ixiasoft
2.2.13.4. Output Clock Duty Cycle Correction
M-Series FPGAs have duty cycle correction capability for the following output clocks:
- 3.2 GHz clock for DDR5/LPDDR5
- PHY clock
- PHY clock tree synchronous reset
- Feedback from PHY clock tree
Perform duty cycle correction after power up and PLL reset. Before performing the duty cycle correction, you must successfully complete power up calibration and static phase error calibration. The PLL asserts the lock signal only when the output clock duty cycle correction is complete.