Visible to Intel only — GUID: sam1425532830232
Ixiasoft
1. Intel® MAX® 10 External Memory Interface Overview
2. Intel® MAX® 10 External Memory Interface Architecture and Features
3. Intel® MAX® 10 External Memory Interface Design Considerations
4. Intel® MAX® 10 External Memory Interface Implementation Guides
5. UniPHY IP References for Intel® MAX® 10 Devices
6. Intel® MAX® 10 External Memory Interface User Guide Archives
7. Document Revision History for the Intel® MAX® 10 External Memory Interface User Guide
2.1. Intel® MAX® 10 I/O Banks for External Memory Interface
2.2. Intel® MAX® 10 DQ/DQS Groups
2.3. Intel® MAX® 10 External Memory Interfaces Maximum Width
2.4. Intel® MAX® 10 Memory Controller
2.5. Intel® MAX® 10 External Memory Read Datapath
2.6. Intel® MAX® 10 External Memory Write Datapath
2.7. Intel® MAX® 10 Address/Command Path
2.8. Intel® MAX® 10 PHY Clock (PHYCLK) Network
2.9. Phase Detector for VT Tracking
2.10. On-Chip Termination
2.11. Phase-Locked Loop
2.12. Intel® MAX® 10 Low Power Feature
3.1. Intel® MAX® 10 DDR2 and DDR3 Design Considerations
3.2. LPDDR2 Design Considerations
3.3. Guidelines: Intel® MAX® 10 DDR3, DDR2, and LPDDR2 External Memory Interface I/O Limitation
3.4. Guidelines: Intel® MAX® 10 Board Design Requirement for DDR2, DDR3, and LPDDR2
3.5. Guidelines: Reading the Intel® MAX® 10 Pin-Out Files
Visible to Intel only — GUID: sam1425532830232
Ixiasoft
2.12. Intel® MAX® 10 Low Power Feature
The Intel® MAX® 10 low power feature is automatically activated when the self refresh or low power down modes are activated. The low power feature sends the afi_mem_clk_disable signal to stop the clock used by the controller.
To conserve power, the Intel® MAX® 10 UniPHY IP core performs the following functions:
- Tri-states the address and command signals except CKE and RESET_N signals
- Disables the input buffer of DDR input
Note: The Intel® MAX® 10 low power feature is available from version 15.0 of the Intel® Quartus® Prime software. To enable this feature, regenerate your Intel® MAX® 10 UniPHY IP core using the Intel® Quartus® Prime software version 15.0 or later.