Visible to Intel only — GUID: kly1459391921121
Ixiasoft
1. Intel® MAX® 10 External Memory Interface Overview
2. Intel® MAX® 10 External Memory Interface Architecture and Features
3. Intel® MAX® 10 External Memory Interface Design Considerations
4. Intel® MAX® 10 External Memory Interface Implementation Guides
5. UniPHY IP References for Intel® MAX® 10 Devices
6. Intel® MAX® 10 External Memory Interface User Guide Archives
7. Document Revision History for the Intel® MAX® 10 External Memory Interface User Guide
2.1. Intel® MAX® 10 I/O Banks for External Memory Interface
2.2. Intel® MAX® 10 DQ/DQS Groups
2.3. Intel® MAX® 10 External Memory Interfaces Maximum Width
2.4. Intel® MAX® 10 Memory Controller
2.5. Intel® MAX® 10 External Memory Read Datapath
2.6. Intel® MAX® 10 External Memory Write Datapath
2.7. Intel® MAX® 10 Address/Command Path
2.8. Intel® MAX® 10 PHY Clock (PHYCLK) Network
2.9. Phase Detector for VT Tracking
2.10. On-Chip Termination
2.11. Phase-Locked Loop
2.12. Intel® MAX® 10 Low Power Feature
3.1. Intel® MAX® 10 DDR2 and DDR3 Design Considerations
3.2. LPDDR2 Design Considerations
3.3. Guidelines: Intel® MAX® 10 DDR3, DDR2, and LPDDR2 External Memory Interface I/O Limitation
3.4. Guidelines: Intel® MAX® 10 Board Design Requirement for DDR2, DDR3, and LPDDR2
3.5. Guidelines: Reading the Intel® MAX® 10 Pin-Out Files
Visible to Intel only — GUID: kly1459391921121
Ixiasoft
6. Intel® MAX® 10 External Memory Interface User Guide Archives
For the latest and previous versions of this user guide, refer to Intel® MAX® 10 External Memory Interface User Guide. If an IP or software version is not listed, the user guide for the previous IP or software version applies.
IP versions are the same as the Intel® Quartus® Prime Design Suite software versions up to v19.1. From Intel® Quartus® Prime Design Suite software version 19.2 or later, IP cores have a new IP versioning scheme.