F-Tile CPRI PHY Multirate Intel® FPGA IP User Guide

Download PDF
ID 710578
Date 12/04/2023
Public
Document Table of Contents
Document Table of Contents x
1. Introduction 2. Interface Overview 3. Parameters 4. Designing with the IP Core 5. Block Description 6. Configuration Registers 7. F-Tile CPRI PHY Multirate Intel FPGA IP User Guide Archives 8. Document Revision History for the F-Tile CPRI PHY Multirate Intel® FPGA IP User Guide
1. Introduction x
1.1. IP Core Overview 1.2. Release Information 1.3. Device Family Support 1.4. Device Speed Grade Support 1.5. Related Documentation
2. Interface Overview x
2.1. Clock Signals 2.2. Reset Signals 2.3. TX MII Interface (64b/66b) 2.4. RX MII Interface (64b/66b) 2.5. Status Interface for 64b/66b Line Rate 2.6. TX Interface (8b/10b) 2.7. RX Interface (8b/10b) 2.8. Status Interface for 8b/10b Line Rate 2.9. TX Tunnel Interface 2.10. Using TX Tunnel Interface 2.11. RX Tunnel Interface 2.12. Using RX Tunnel Interface 2.13. Status Interface for Tunnel Line Rate 2.14. Serial Interface 2.15. CPRI PHY Reconfiguration Interface 2.16. Datapath Avalon Memory-Mapped Interface 2.17. PMA Avalon Memory-Mapped Interface
2.1. Clock Signals x
2.1.1. Required Clock Frequencies
3. Parameters x
3.1. Sub Profile Parameters Validation
4. Designing with the IP Core x
4.1. Installing and Licensing Intel® FPGA IP Cores 4.2. Specifying the IP Core Parameters and Options 4.3. Generated File Structure 4.4. Dynamic Reconfiguration Settings
4.1. Installing and Licensing Intel® FPGA IP Cores x
4.1.1. Intel® FPGA IP Evaluation Mode
4.2. Specifying the IP Core Parameters and Options x
4.2.1. Reference and System PLL Clock for your IP Design
5. Block Description x
5.1. Latency Measurement 5.2. CDR Clock Output 5.3. RX PMA Adaptation
5.1. Latency Measurement x
5.1.1. Deterministic Latency 5.1.2. Calculation for 64b/66b Datapath
1. Introduction
2. Interface Overview
3. Parameters
4. Designing with the IP Core
5. Block Description
6. Configuration Registers
7. F-Tile CPRI PHY Multirate Intel FPGA IP User Guide Archives
8. Document Revision History for the F-Tile CPRI PHY Multirate Intel® FPGA IP User Guide

5.3. RX PMA Adaptation

The RX PMA Adaptation mode is pre-configured for each line rate during the IP generation. The following table lists the most optimal mode for each line rate. In auto-adaptation, the PMA performs dynamic adaptation on the RX link. In manual adaptation, there is no dynamic adaptation; you can tune the RX link using the static equalization taps.
Table 36.  RX PMA Adaptation Mode
Line Rate (Gbps) RX PMA Adaptation Mode
24.33024 Auto Adaptation
12.16512 Auto Adaptation
10.1376 Auto Adaptation
9.8304 Auto Adaptation
6.144 Manual Adaptation
4.9152 Manual Adaptation
3.072 Manual Adaptation
2.4576 Manual Adaptation
1.2288 Manual Adaptation
Level Two Title