Visible to Intel only — GUID: sam1403482362529
Ixiasoft
1. Stratix® 10 High-Speed LVDS I/O Overview
2. Stratix® 10 High-Speed LVDS I/O Architecture and Features
3. Stratix 10 High-Speed LVDS I/O Design Considerations
4. Stratix® 10 High-Speed LVDS I/O Implementation Guides
5. LVDS SERDES Intel® FPGA IP References
6. Stratix® 10 High-Speed LVDS I/O User Guide Archives
7. Document Revision History for the Stratix® 10 High-Speed LVDS I/O User Guide
3.1. PLLs and Clocking for Stratix® 10 Devices
3.2. Source-Synchronous Timing Budget
3.3. Guideline: LVDS SERDES IP Core Instantiation
3.4. Guideline: LVDS SERDES Pin Pairs for Soft-CDR Mode
3.5. Guideline: LVDS Transmitters and Receivers in the Same I/O Bank
3.6. Guideline: LVDS SERDES Limitation for Stratix® 10 GX 400, SX 400, and TX 400
3.1.1. Clocking Differential Transmitters
3.1.2. Clocking Differential Receivers
3.1.3. Guideline: LVDS Reference Clock Source
3.1.4. Guideline: Use PLLs in Integer PLL Mode for LVDS
3.1.5. Guideline: Use High-Speed Clock from PLL to Clock LVDS SERDES Only
3.1.6. Guideline: Pin Placement for Differential Channels
3.1.7. LVDS Interface with External PLL Mode
Visible to Intel only — GUID: sam1403482362529
Ixiasoft
2.5.1. Receiver Blocks in Stratix® 10 Devices
The Stratix® 10 differential receiver has the following hardware blocks:
- DPA block
- Synchronizer
- Data realignment block (bit slip)
- Deserializer
Figure 8. Receiver Block DiagramThis figure shows the hardware blocks of the receiver. In SDR and DDR modes, the data width from the IOE is 1 and 2 bits, respectively. The deserializer includes shift registers and parallel load registers, and sends a maximum of 10 bits to the internal logic.