Visible to Intel only — GUID: sam1403482552519
Ixiasoft
1. Stratix® 10 High-Speed LVDS I/O Overview
2. Stratix® 10 High-Speed LVDS I/O Architecture and Features
3. Stratix 10 High-Speed LVDS I/O Design Considerations
4. Stratix® 10 High-Speed LVDS I/O Implementation Guides
5. LVDS SERDES Intel® FPGA IP References
6. Stratix® 10 High-Speed LVDS I/O User Guide Archives
7. Document Revision History for the Stratix® 10 High-Speed LVDS I/O User Guide
3.1. PLLs and Clocking for Stratix® 10 Devices
3.2. Source-Synchronous Timing Budget
3.3. Guideline: LVDS SERDES IP Core Instantiation
3.4. Guideline: LVDS SERDES Pin Pairs for Soft-CDR Mode
3.5. Guideline: LVDS Transmitters and Receivers in the Same I/O Bank
3.6. Guideline: LVDS SERDES Limitation for Stratix® 10 GX 400, SX 400, and TX 400
3.1.1. Clocking Differential Transmitters
3.1.2. Clocking Differential Receivers
3.1.3. Guideline: LVDS Reference Clock Source
3.1.4. Guideline: Use PLLs in Integer PLL Mode for LVDS
3.1.5. Guideline: Use High-Speed Clock from PLL to Clock LVDS SERDES Only
3.1.6. Guideline: Pin Placement for Differential Channels
3.1.7. LVDS Interface with External PLL Mode
Visible to Intel only — GUID: sam1403482552519
Ixiasoft
3.2.1. Differential Data Orientation
There is a set relationship between an external clock and the incoming data. For operations at 1 Gbps and a serialization factor of 10, the external clock is multiplied by 10. You can set phase-alignment in the PLL to coincide with the sampling window of each data bit. The data is sampled on the falling edge of the multiplied clock.
Figure 27. Bit Orientation in the Quartus® Prime SoftwareThis figure shows the data bit orientation of the x10 mode.