Visible to Intel only — GUID: csl1574304721827
Ixiasoft
2.1. Arria® 10 DisplayPort SST Parallel Loopback Design Features
2.2. Arria® 10 DisplayPort MST Parallel Loopback Design Features
2.3. Enabling Adaptive Sync Support
2.4. Arria® 10 DisplayPort SST TX-only or RX-only Design Features
2.5. Design Components
2.6. Clocking Scheme
2.7. Interface Signals and Parameters
2.8. Hardware Setup
2.9. Simulation Testbench
2.10. DisplayPort Transceiver Reconfiguration Flow
2.11. Transceiver Lane Configurations
Visible to Intel only — GUID: csl1574304721827
Ixiasoft
3.4.1. Setting Up the Hardware
The first stage of the demonstration is hardware setup.
To set up the hardware, follow these steps:
- Connect the Bitec DisplayPort FMC daughter card to the Arria® 10 development kit at FMC port A.
- Connect the Arria® 10 development kit to your PC using a USB cable.
- Connect a DisplayPort cable from the DisplayPort RX connector on the Bitec DisplayPort FMC daughter card to an HDCP-enabled DisplayPort device, such as a graphic card with DisplayPort output.
- Connect another DisplayPort cable from the DisplayPort TX connector on the Bitec DisplayPort FMC daughter card to an HDCP-enabled DisplayPort device, such as a display monitor with DisplayPort input.