AN 813: Hierarchical Partial Reconfiguration over PCI Express* Reference Design: for Intel® Arria® 10 Devices

Download PDF
ID 683730
Date 1/20/2021
Public
Document Table of Contents
Document Table of Contents x
1. Hierarchical Partial Reconfiguration over PCI Express* Reference Design for Intel® Arria® 10 Devices
1. Hierarchical Partial Reconfiguration over PCI Express* Reference Design for Intel® Arria® 10 Devices x
1.1. Reference Design Overview 1.2. Floorplanning 1.3. Getting Started 1.4. Reference Design Components 1.5. Compiling the Reference Design 1.6. Bringing Up the Reference Design 1.7. Testing the Reference Design 1.8. Extending the Reference Design with Custom Persona 1.9. Reference Design Files 1.10. Document Revision History for AN 813: Hierarchical Partial Reconfiguration over PCI Express* Reference Design for Intel® Arria® 10 Devices
1.1. Reference Design Overview x
1.1.1. Clocking Scheme 1.1.2. Memory Address Mapping
1.3. Getting Started x
1.3.1. Hardware and Software Requirements 1.3.2. Installing the Intel® Arria® 10 GX FPGA Development Kit 1.3.3. Installing the Linux Driver
1.4. Reference Design Components x
1.4.1. BSP Top
1.4.1. BSP Top x
1.4.1.1. Intel Arria 10/Cyclone 10 Hard IP for PCI Express IP 1.4.1.2. External Memory Interfaces Intel® Arria® 10 FPGA IP 1.4.1.3. Design Top
1.4.1.3. Design Top x
1.4.1.3.1. Global Reset Logic 1.4.1.3.2. PR Region Wrapper 1.4.1.3.3. Parent PR Region 1.4.1.3.4. Partial Reconfiguration Region Controller Intel® FPGA IP 1.4.1.3.5. Partial Reconfiguration Logic
1.7. Testing the Reference Design x
1.7.1. program_fpga_jtag 1.7.2. fpga-configure example_host_uio
example_host_uio x
1.7.3.1. Compiling the Example Applications 1.7.3.2. Programming the Design Using Example Applications
1. Hierarchical Partial Reconfiguration over PCI Express* Reference Design for Intel® Arria® 10 Devices

1.3.2. Installing the Intel® Arria® 10 GX FPGA Development Kit

For complete instructions on installing and powering the Intel® Arria® 10 GX FPGA development board in your Linux system, refer to Intel® Arria® 10 FPGA Development Kit User Guide.
Note: Before powering the board, set the switch 4 (FACTORY) of the DIP switch bank (SW6) to ON. Setting this switch to ON loads the factory image area of the flash memory at boot time. Program the reference design into this factory image area. For complete instructions on flashing the reference design onto the board, refer to Bringing Up the Reference Design.
Related Information
Level Two Title