Visible to Intel only — GUID: cit1507086390583
Ixiasoft
1. Intel® Stratix® 10 SEU Mitigation Overview
2. Intel® Stratix® 10 Mitigation Techniques for CRAM
3. Secure Device Manager ECC Error Detection
4. Intel® Stratix® 10 SEU Mitigation Implementation Guides
5. Advanced SEU Detection Intel® FPGA IP References
6. Intel® Stratix® 10 Fault Injection Debugger References
7. Intel® Stratix® 10 SEU Mitigation User Guide Archives
8. Document Revision History for the Intel® Stratix® 10 SEU Mitigation User Guide
4.1. Setting SEU_ERROR Pin
4.2. Intel® Quartus® Prime SEU Software Settings
4.3. Enabling Priority Scrubbing
4.4. Performing Hierarchy Tagging
4.5. Programming Sensitivity Map Header File into Memory
4.6. Performing Lookup for Sensitivity Map Header
4.7. Using the Fault Injection Debugger
4.8. Analyzing SEU Errors Using Signal Tap
4.9. Intel® Quartus® Prime Software SEU FIT Reports
Visible to Intel only — GUID: cit1507086390583
Ixiasoft
2.5.1. Intel® Quartus® Prime Fault Injection Debugger
You can detect and debug single event upset (SEU) using the Fault Injection Debugger in the Intel® Quartus® Prime software. Use the debugger to inject errors into the configuration RAM (CRAM) of an Intel® Stratix® 10 FPGA device.
With the Fault Injection Debugger, you can operate the FPGA in the system and inject random CRAM bit flips. These simulated SEU strikes allow you to observe how the FPGA and the system detect and recover from SEUs. Depending on the results, you can refine the system's recovery sequence.
Figure 6. Fault Injection Debugger Overview Block Diagram for Intel® Stratix® 10 Devices
The Fault Injection Debugger allows you to perform the following:
- Inject single-bit error to either:
- Random location
- Specified region
- Report error information by reading the error message queue
Note: The Fault Injection Debugger does not support injecting SDM ECC error in Intel® Stratix® 10 devices.
Note: You must have a licensed version of the Intel® Quartus® Prime software to use the Fault Injection Debugger tool.