Visible to Intel only — GUID: yxe1557436545111
Ixiasoft
1.1. Generating Primary Device Programming Files
1.2. Generating Secondary Programming Files
1.3. Enabling Bitstream Security for Intel® Stratix® 10 Devices
1.4. Enabling Bitstream Encryption or Compression for Intel® Arria® 10 and Intel® Cyclone® 10 GX Devices
1.5. Generating Programming Files for Partial Reconfiguration
1.6. Generating Programming Files for Intel® FPGA Devices with Hard Processor Systems
1.7. Scripting Support
1.8. Generating Programming Files Revision History
2.1. Intel® Quartus® Prime Programmer
2.2. Programming and Configuration Modes
2.3. Basic Device Configuration Steps
2.4. Specifying the Programming Hardware Setup
2.5. Programming with Flash Loaders
2.6. Verifying the Programming File Source with Project Hash
2.7. Using PR Bitstream Security Verification ( Intel® Stratix® 10 Designs)
2.8. Stand-Alone Programmer
2.9. Programmer Settings Reference
2.10. Scripting Support
2.11. Using the Intel® Quartus® Prime Programmer Revision History
2.9.1. Device & Pin Options Dialog Box
2.9.2. More Security Options Dialog Box
2.9.3. Output Files Tab Settings (Programming File Generator)
2.9.4. Input Files Tab Settings (Programming File Generator)
2.9.5. Bitstream Co-Signing Security Settings (Programming File Generator)
2.9.6. Configuration Device Tab Settings
2.9.7. Add Partition Dialog Box (Programming File Generator)
2.9.8. Convert Programming File Dialog Box
2.9.9. Compression and Encryption Settings (Convert Programming File)
2.9.10. SOF Data Properties Dialog Box (Convert Programming File)
2.9.11. Select Devices (Flash Loader) Dialog Box
Visible to Intel only — GUID: yxe1557436545111
Ixiasoft
2.5.2. Full Erase of Flash Memory Sectors
When performing flash memory erase operations via JTAG and a .jic file, the Intel® Quartus® Prime Programmer erases only the flash memory sectors that the .jic specifies.
For example, if you specify a .jic file containing only a 13.6Mbits FPGA image on an EPCQ64A device, the Programmer erases only the bottom 13.6Mbits, and does not erase the remaining 50.4Mbits of data.
To erase the entire flash memory device contents, do not specify a .jic file for flash programming. Rather, manually add the flash device to the associated FPGA device chain by following these steps:
- In the Programmer, right-click the target FPGA device, and then click Edit > Attach Flash Device.
- Select the appropriate flash device from the list. The Factory Default Serial Flash Loader loads for the FPGA automatically.
- In the Programmer, enable the Erase checkbox, and click Start to start the erase operation.