Visible to Intel only — GUID: cyo1673422487492
Ixiasoft
1. Agilex™ 5 Clocking and PLL Overview
2. Agilex™ 5 Clocking and PLL Architecture and Features
3. Agilex™ 5 Clocking and PLL Design Considerations
4. Clock Control Intel® FPGA IP Core
5. IOPLL Intel® FPGA IP Core
6. I/O PLL Reconfiguration
7. Document Revision History for the Clocking and PLL User Guide: Agilex™ 5 FPGAs and SoCs
2.2.1. PLL Features
2.2.2. PLL Usage
2.2.3. PLL Locations
2.2.4. PLL Architecture
2.2.5. PLL Control Signals
2.2.6. PLL Feedback Modes
2.2.7. Clock Multiplication and Division
2.2.8. Programmable Phase Shift
2.2.9. Programmable Duty Cycle
2.2.10. PLL Cascading
2.2.11. PLL Input Clock Switchover
2.2.12. PLL Reconfiguration and Dynamic Phase Shift
2.2.13. PLL Calibration
3.1. Guidelines: Clock Switchover
3.2. Guidelines: Timing Closure
3.3. Guidelines: Resetting the PLL
3.4. Guidelines: Configuration Constraints
3.5. Clocking Constraints
3.6. IP Core Constraints
3.7. Guideline: Achieving 5% Duty Cycle for fOUT_EXT ≥ 300 MHz Using tx_outclk Port from LVDS SERDES Intel® FPGA IP
6.1. Release Information for EMIF Calibration IP
6.2. Implementing HSIO I/O PLL Reconfiguration using EMIF Calibration IP
6.3. Implementing HVIO I/O PLL Reconfiguration
6.4. Reconfiguration Guideline for I/O PLLs
6.5. Axilite Interface Ports in the EMIF Calibration IP
6.6. Address Bus and Data Bus Settings
6.7. Design Example
Visible to Intel only — GUID: cyo1673422487492
Ixiasoft
2.2.4. PLL Architecture
Figure 10. I/O Bank I/O PLL High-Level Block Diagram for Agilex™ 5 Devices
Figure 11. Fabric-Feeding I/O PLL High-Level Block Diagram for Agilex™ 5 Devices
Note:
- The dedicated clock inputs can feed only one PLL through the dedicated clock path. To feed the second PLL, the clock must be routed onto a global clock network.
- If a global reference clock source is required, this clock must be promoted using the Assignment Editor to promote the PLL refclk to a global signal.
- inclk1 is not available for fabric-feeding I/O PLL located in HVIO block since clock switchover feature is not supported.