Visible to Intel only — GUID: ccz1596509797913
Ixiasoft
1. Agilex™ 7 M-Series General-Purpose I/O Overview
2. Agilex™ 7 M-Series GPIO-B Banks
3. Agilex™ 7 M-Series HPS I/O Banks
4. Agilex™ 7 M-Series SDM I/O Banks
5. Agilex™ 7 M-Series I/O Troubleshooting Guidelines
6. GPIO Intel® FPGA IP
7. Programmable I/O Features Description
8. Documentation Related to the Agilex™ 7 General-Purpose I/O User Guide: M-Series
9. Agilex™ 7 General-Purpose I/O User Guide: M-Series Archives
10. Document Revision History for the Agilex™ 7 General-Purpose I/O User Guide: M-Series
2.5.1. I/O Standard Placement Restrictions for True Differential I/Os
2.5.2. Placement Restrictions for True Differential and Single-Ended I/O Standards in the Same or Adjacent GPIO-B Bank
2.5.3. VREF Sources and Input Standards Grouping
2.5.4. GPIO-B Pin Restrictions for External Memory Interfaces
2.5.5. RZQ Pin Requirement
2.5.6. I/O Standards Implementation Based on VCCIO_PIO Voltages
2.5.7. I/O Standard Selection and I/O Bank Supply Compatibility Check
2.5.8. Simultaneous Switching Noise
2.5.9. HPS Shared I/O Requirements
2.5.10. Clocking Requirements
2.5.11. SDM Shared I/O Requirements
2.5.12. Unused Pins
2.5.13. VCCIO_PIO Supply for Unused GPIO-B Banks
2.5.14. GPIO-B Pins During Power Sequencing
2.5.15. Drive Strength Requirement for GPIO-B Input Pins
2.5.16. Maximum DC Current Restrictions
2.5.17. 1.05 V, 1.1 V, or 1.2 V I/O Interface Voltage Level Compatibility
2.5.18. Connection to True Differential Signaling Input Buffers During Device Reconfiguration
2.5.19. LVSTL700 I/O Standards Differential Pin Pair Requirements
2.5.20. Implementing a Pseudo Open Drain
2.5.21. Allowed Duration for Using RT OCT
2.5.22. Single-Ended Strobe Signal Differential Pin Pair Restriction
2.5.23. Implementing SLVS-400 Standard at 1.1 V VCCIO_PIO Sub-bank
6.1. Release Information for GPIO Intel® FPGA IP
6.2. Generating the GPIO Intel® FPGA IP
6.3. GPIO Intel® FPGA IP Parameter Settings
6.4. GPIO Intel® FPGA IP Interface Signals
6.5. GPIO Intel® FPGA IP Architecture
6.6. Verifying Resource Utilization and Design Performance
6.7. GPIO Intel® FPGA IP Timing
6.8. GPIO Intel® FPGA IP Design Examples
Visible to Intel only — GUID: ccz1596509797913
Ixiasoft
2.5.15. Drive Strength Requirement for GPIO-B Input Pins
Each GPIO-B input pin with programmable pull-up feature turned on requires 1 mA of drive strength. The connected output buffer must provide a minimum of 1 mA to the pin.
If an output buffer drives two input pins, the output buffer must provide 2 mA to the input pins. Increase the drive strength current according to the number of input pins the output buffer drives.
If you connect an output buffer to multiple input pins and one of the input pins has programmable pull-up feature enabled, you must turn on the same programmable feature on all of the other input pins.