Nios® V Embedded Processor Design Handbook

ID 726952
Date 5/26/2023
Public

A newer version of this document is available. Customers should click here to go to the newest version.

Document Table of Contents

4.3. Nios® V Processor Booting Methods

There are a few methods to boot up the Nios® V processor in Intel FPGA devices. The methods to boot up Nios® V processor vary according to the flash memory selection and device families.

Table 12.  Supported Flash Memories with Respective Boot Options
Supported Boot Memories Device Nios® V Processor Booting Methods Application Runtime Location Boot Copier
Configuration QSPI Flash (for Active Serial configuration) Control block-based devices (with Generic Serial Flash Interface Intel FPGA IP) 2

Nios® V processor application execute-in-place from configuration QSPI flash

Configuration QSPI flash (XIP) + OCRAM/ External RAM (for writable data sections) alt_load() function
Nios® V processor application copied from configuration QSPI flash to RAM using boot copier OCRAM/ External RAM GSFI bootloader
SDM-based devices (with Mailbox Client Intel FPGA IP). 2 Nios® V processor application copied from configuration QSPI flash to RAM using boot copier OCRAM/ External RAM SDM bootloader

On-chip Memory (OCRAM)

All supported Intel FPGA devices 2 Nios® V processor application execute-in-place from OCRAM OCRAM alt_load() function
Figure 12.  Nios® V Processor Boot Flow
2 Refer to AN 980: Nios® V Processor Intel® Quartus® Prime Software Support for the device list.