AN 841: Signal Tap Tutorial for Intel® Stratix® 10 Partial Reconfiguration Design

Download PDF
ID 683875
Date 5/07/2018
Public

A newer version of this document is available. Customers should click here to go to the newest version.

Document Table of Contents
Document Table of Contents x
1. Tutorial Overview 2. Tutorial Walkthrough 3. Tutorial Results 4. Document Revision History for AN 841: Signal Tap Tutorial for Intel® Stratix® 10 Partial Reconfiguration Design
1. Tutorial Overview x
1.1. PR Debug Considerations 1.2. Tutorial Software and Hardware Requirements 1.3. Tutorial Design Description 1.4. Downloading the Tutorial Design
1.4. Downloading the Tutorial Design x
1.4.1. Tutorial Design Files
2. Tutorial Walkthrough x
2.1. Step 1: Getting Started 2.2. Step 2: Preparing the Base Revision 2.3. Step 3: Preparing the Implementation Revisions for Debug 2.4. Step 4: Tapping Signals in the Implementation Persona 2.5. Step 5: Configuring Data Acquisition 2.6. Step 6: Setting Trigger Conditions 2.7. Step 7: Generating Programming Files 2.8. Step 8: Programming the Board 2.9. Step 9: Performing Data Acquisition
2.2. Step 2: Preparing the Base Revision x
2.2.1. Preparing the Static Region 2.2.2. Preparing the Default PR Persona
2.5. Step 5: Configuring Data Acquisition x
2.5.1. Add Acquisition Clock 2.5.2. Add Storage Parameters
3. Tutorial Results x
3.1. Waveforms for Slow Implementation 3.2. Waveforms for Default Implementation 3.3. Waveforms for Empty Implementation
1. Tutorial Overview
2. Tutorial Walkthrough
3. Tutorial Results
4. Document Revision History for AN 841: Signal Tap Tutorial for Intel® Stratix® 10 Partial Reconfiguration Design

2.6. Step 6: Setting Trigger Conditions

These steps direct the Signal Tap Logic Analyzer to record data only after u_blinking_led|led_three_on or u_blinking_led|led_two_on does a rising edge transition.

  1. In the Setup tab of the Signal Tap Logic Analyzer window, turn on the box under the Trigger Condition column
  2. Open the drop-down menu, and select Basic OR.
  3. For u_blinking_led|led_three_on and u_blinking_led|led_two_on, turn on Trigger Enable and select Rising Edge as the trigger type.
  4. For all the other signals, turn off Trigger Enable.
Figure 19. Trigger Conditions
Level Two Title