AN 728: I/O PLL Reconfiguration and Dynamic Phase Shift for Intel® Arria® 10 and Intel Cyclone® 10 GX Devices

Download PDF
ID 683845
Date 8/08/2022
Public
Document Table of Contents
Document Table of Contents x
I/O PLL Reconfiguration and Dynamic Phase Shift for Intel® Arria® 10 and Intel® Cyclone® 10 GX Devices
I/O PLL Reconfiguration and Dynamic Phase Shift for Intel® Arria® 10 and Intel® Cyclone® 10 GX Devices x
Implementing I/O PLL Reconfiguration in the PLL Reconfig IP Core Implementing I/O PLL Dynamic Phase Shift in the IOPLL IP Core Design Considerations Using the Design Examples Document Revision History for AN 728: I/O PLL Reconfiguration and Dynamic Phase Shift for Intel® Arria® 10 and Intel® Cyclone® 10 GX Devices
Implementing I/O PLL Reconfiguration in the PLL Reconfig IP Core x
Avalon® Memory-Mapped Interface Ports in the PLL Reconfig IP Core Connecting the IOPLL and PLL Reconfig IP Cores Connectivity between the IOPLL and PLL Reconfig IP Cores I/O PLL Reconfiguration Write Operation I/O PLL Reconfiguration Read Operation Address Bus and Data Bus Settings .mif Streaming Reconfiguration
I/O PLL Reconfiguration Write Operation x
Write Operation for .mif Streaming Reconfiguration
Address Bus and Data Bus Settings x
Address Bus and Data Bus Setting for Counter Setting Reconfiguration Address Bus and Data Bus Setting for Dynamic Phase Shift Address Bus and Data Bus Setting for Bandwidth Setting Reconfiguration Data Bus Setting for Loop Filter and Charge Pump Settings Address Bus and Data Bus Setting for .mif Streaming Reconfiguration
.mif Streaming Reconfiguration x
.mif File Format .mif Streaming Reconfiguration Operation Codes
Implementing I/O PLL Dynamic Phase Shift in the IOPLL IP Core x
Dynamic Phase Shift Ports in the IOPLL IP Core I/O PLL Dynamic Phase Shift Operation
Using the Design Examples x
Design Example 1: I/O PLL Reconfiguration Design Example 2: .mif Streaming Reconfiguration Design Example 3: I/O PLL Dynamic Phase Shift
I/O PLL Reconfiguration and Dynamic Phase Shift for Intel® Arria® 10 and Intel® Cyclone® 10 GX Devices

I/O PLL Dynamic Phase Shift Operation

To perform dynamic phase shift operation for an I/O PLL in the IOPLL IP core, follow these steps:

  1. Set the value for updn, cntsel[4..0], and num_phase_shift[2..0] ports.
  2. Assert phase_en port for at least two scanclk cycles.

Each phase_en pulse indicates one dynamic phase shift operation. The phase_done output goes low to indicate that dynamic phase shift is in progress. You can only assert the phase_en signal after the phase_done signal goes from low to high.

The updn, cntsel[4..0], and num_phase_shift[2..0] ports are synchronous to the scanclk cycle.

When the phase_done signal transitions from high to low, the phase_done signal is synchronous to the rising edge of the scanclk signal. The transition from low to high is asynchronous to the scanclk signal.

Depending on the VCO and scanclk frequency, the low time of the phase_done signal may be greater than or less than one scanclk cycle.

Level Two Title