PHY Lite for Parallel Interfaces Intel® FPGA IP User Guide

ID 683716
Date 4/10/2023
Public

A newer version of this document is available. Customers should click here to go to the newest version.

Document Table of Contents

3.3.2.2. Output Path Signals

Table 37.  Output Path SignalsOutput path signals are signals that are available when you set the Pin Type parameter to either Output or Bidirectional. The <n> in the signal names below represents the group number in the IP.
Signal Name Direction Width Description
group_oe_from_core Input

Quarter-rate: 4

Output enable signal from FPGA core. Synchronous to the core_clk_out output from the IP.

This signal is shared across all groups.

group_<n>_data_from_core Input

Quarter rate-DDR: 8 x PIN_WIDTH

Quarter-rate SDR: 4 x PIN_WIDTH

Data signal from Intel FPGA core. Synchronous to the core_clk_out output from the IP.
group_strobe_out_en Input

Quarter-rate: 4

Strobe output enable from FPGA core. Synchronous to the core_clk_out output from the IP.

This signal is shared across all groups.

group_<n>_data_out /group_<n>_data_io Output/Bidirectional 1 to 34 Data output from the IP. Synchronous to the group_<n>_strobe_out or group_<n>_strobe_io output from the IP.

If the Pin Type parameter is set to Output, the group_<n>_data_out signals are used. If the Pin Type parameter is set to Bidirectional, the group_<n>_data_io signals are used.

group_<n>_strobe_out/group_strobe_io/group_<n>_strobe_io Output/Bidirectional 1 Positive output strobe from the IP. If the Pin Type is set to Output, the group_<n>_strobe_out signal is used. If the Pin Type is set to Bidirectional the group_<n>_strobe_io signal is used.
group_<n>_strobe_out_n /group_<n>_strobe_io_n Output/Bidirectional 1 Negative output strobe fro the IP.

This is used if the Strobe Configuration is set to Differential.

If the Pin Type is set to Output, the group_<n>_strobe_out_n signal is used. If the Pin Type is set to Bidirectional, the group_<n>_strobe_io_n signal is used.