MIPI CSI-2 Intel® FPGA IP Design Example User Guide

Download PDF
ID 813931
Date 10/07/2024
Public
Document Table of Contents
Document Table of Contents x
1. MIPI CSI-2 Intel® FPGA IP Design Example Quick Start Guide 2. MIPI CSI-2 Intel® FPGA IP Design Example 3. Document Revision History for the MIPI CSI-2 Intel® FPGA IP Design Example User Guide
1. MIPI CSI-2 Intel® FPGA IP Design Example Quick Start Guide x
1.1. Generating the Design 1.2. Simulating the Design 1.3. Directory Structure 1.4. Compiling the Design
1.1. Generating the Design x
1.1.1. Design Example Parameters
2. MIPI CSI-2 Intel® FPGA IP Design Example x
2.1. Agilex™ 5 MIPI CSI-2 RX+TX Design 2.2. Agilex™ 5 MIPI CSI-2 RX-only Design 2.3. Software Requirements 2.4. Functional Description 2.5. Simulation
2.4. Functional Description x
2.4.1. MIPI CSI-2 Design Components 2.4.2. MIPI CSI-2 IP Design Example Reset Scheme 2.4.3. MIPI CSI-2 IP Design Example Clocking Scheme
2.5. Simulation x
2.5.1. Data Signal Checking 2.5.2. Verification 2.5.3. Display Messages 2.5.4. Waveform Plotting 2.5.5. Structure 2.5.6. Known Limitations
2.5.5. Structure x
2.5.5.1. Top Level Testbench 2.5.5.2. PHY-Protocol Interface (PPI) Loopback 2.5.5.3. Test Generator
1. MIPI CSI-2 Intel® FPGA IP Design Example Quick Start Guide
2. MIPI CSI-2 Intel® FPGA IP Design Example
3. Document Revision History for the MIPI CSI-2 Intel® FPGA IP Design Example User Guide

2.5.4. Waveform Plotting

The simulation allows plotting waveforms for graphical analysis.

To use GUI mode for ModelSim or QuestaSim, Altera recommends that you open the simulator GUI and run source sim_GUI.do. You can then add the signals you want to plot before running the simulation.

To use GUI mode for Synopsys VCSMX, first run source sim.sh as you do for command line execution. Then, type ./simv -gui to open the simulator GUI. You can then add the signals you want to plot before running the simulation.

Level Two Title