Visible to Intel only — GUID: igi1662697854160
Ixiasoft
2.1. Stratix® 10 DisplayPort SST Parallel Loopback Design Features
2.2. Stratix® 10 DisplayPort SST TX-only or RX-only Design Features
2.3. Design Components
2.4. Clocking Scheme
2.5. Interface Signals and Parameters
2.6. Hardware Setup
2.7. Simulation Testbench
2.8. DisplayPort Transceiver Reconfiguration Flow
2.9. Transceiver Lane Configurations
Visible to Intel only — GUID: igi1662697854160
Ixiasoft
2.2.2. Stratix® 10 DisplayPort SST RX-only Design Features
This RX-only design example demonstrates the transmission of a single video stream from DisplayPort sink with Pixel CLock Recovery (PCR).
Figure 8. Stratix® 10 DisplayPort SST RX-only
- To generate this RX-only variant, turn on the DisplayPort sink RX SUPPORT DP and the DisplayPort source TX SUPPORT DP parameters.
- This variant uses the standard VSYNC/HSYNC/DE video interface, while the DisplayPort source TX SUPPORT IM ENABLE parameter is turned off.
- The IOPLL drives video clock at a fixed frequency (in this case, 300 MHz by default).
- If you configure the DisplayPort sink MAX LINK RATE parameter to HBR3 or MAX LINK RATE parameter to HBR2 and PIXELS PER CLOCK to DUAL, the video clock runs at 300 MHz to support 4Kp60 pixel rate (594/2 = 297 MHz). Otherwise, the video clock runs at 160 MHz.
- The DisplayPort sink receives video from an external video source such as a GPU and decodes it for the parallel video interface.
- The design uses the pixel recovery clock (PCR) to recover the pixel clock according to the received MSA information from the sink and converts the RX parallel video interface to the standard VSYNC/HSYNC/DE interface.