AN 729: Implementing JESD204B IP Core System Reference Design with Nios II Processor

Download PDF
ID 683844
Date 5/04/2015
Public
Document Table of Contents
Document Table of Contents x
1. Implementing JESD204B IP Core System Reference Design with Nios II Processor As Control Unit
1. Implementing JESD204B IP Core System Reference Design with Nios II Processor As Control Unit x
1.1. Reference Design Overview 1.2. Hardware and Software Requirements 1.3. Hardware Setup 1.4. System Modules 1.5. Reference Design Files 1.6. Generating Programming File 1.7. Top Level HDL Parameters 1.8. Setting Up the Software Command Line Environment 1.9. User Commands 1.10. Dynamic Reconfiguration 1.11. Customize the C code 1.12. AN 729 Document Revision History
1.4. System Modules x
1.4.1. Qsys System
1.4.1. Qsys System x
1.4.1.1. JESD204B Subsystem 1.4.1.2. Nios II Subsystem
1.4.1.1. JESD204B Subsystem x
1.4.1.1.1. Configuring the JESD204B IP core parameters in QSYS 1.4.1.1.2. Reset Sequencer 1.4.1.1.3. Transceiver PHY Reset Controller and ATX PLL 1.4.1.1.4. JESD204B Subsystem Address Map
1.4.1.2. Nios II Subsystem x
1.4.1.2.1. Nios II Subsystem Address Map
1.5. Reference Design Files x
1.5.1. FPGA Pin Assignments
1.10. Dynamic Reconfiguration x
1.10.1. Data Rate Reconfiguration
1.10.1. Data Rate Reconfiguration x
1.10.1.1. Customizing the Data Rate Reconfiguration Parameters
1.11. Customize the C code x
1.11.1. Sub Functions in main.c Source File 1.11.2. Functions in rules.c Source File 1.11.3. Custom Peripheral Access Macros in macros.c Source File
1. Implementing JESD204B IP Core System Reference Design with Nios II Processor As Control Unit

1.4.1.1.1. Configuring the JESD204B IP core parameters in QSYS

To change the initial configuration parameters of the JESD204B IP core in Qsys, follow these steps:

  1. Launch the Quartus II software.
  2. On the File menu, click Open.
  3. Browse and select the jesd204b_ed_qsys.qsys file located in the project directory.
  4. Click Open to view the Qsys system.
  5. Right-click on the jesd204b_subsystem_0 module.
  6. Select the Drill into subsystem option.
  7. Double-click the jesd204b module. The parameter editor window appears.
  8. After you are done entering the parameter values, click the Move to the top of hierarchy button on the top of the Qsys window to move back to the top level Qsys project hierarchy (jesd204b_ed_qsys.qsys).
  9. Click the Generate HDL button on the bottom right corner of the Qsys window.
  10. After Qsys is done generating the HDL, click the Finish button on the bottom right corner of the Qsys window.
  11. Recompile your design.
Level Two Title