Intel® Quartus® Prime Pro Edition User Guide: Partial Reconfiguration

ID 683834
Date 4/03/2023
Public

A newer version of this document is available. Customers should click here to go to the newest version.

Document Table of Contents

3.8.6.1. Monitoring the SDM

The SDM simulation model exposes the following additional simulation-only ports through the altera_config_stream_endpoint module:

  • sim_only_state
  • sim_only_pr_id
Figure 86. SDM Partial Reconfiguration Simulation Model - altera_config_stream_endpoint Module

You connect these simulation ports to the config_stream_endpoint_pr_if SystemVerilog interface. This connection allows monitoring of the SDM using your testbench’s SDM monitor.

The Intel® Quartus® Prime software automatically instantiates the config_stream_endpoint_pr_if interface when generating the simulation file set of the Partial Reconfiguration Controller and the Partial Reconfiguration External Configuration Controller IP.

You can obtain a reference to the config_stream_endpoint_pr_if that the IP instantiates by using the following singleton:

intel_pr_mailbox_test_pkg::config_stream_endpoint_pr_if_mgr

The following example shows this reference:

virtual config_stream_endpoint_pr_if pr_mailbox_if

intel_pr_mailbox_test_pkg::config_stream_endpoint_pr_if_mgr pr_mbox_mgr;

// Get the PR Config Stream Endpoint from the pr_mbox manager
pr_mbox_mgr = intel_pr_mailbox_test_pkg::config_stream_endpoint_pr_if_mgr\
   ::get();
pr_mailbox_if = pr_mbox_mgr.if_ref;

The following is the code for the config_stream_endpoint_pr_if interface:

interface config_stream_endpoint_pr_if (input logic clk);
    wire [31:0] sim_only_state;
    wire [31:0] sim_only_pr_id;
endinterface : config_stream_endpoint_pr_if

Refer to the following file for more information on the config_stream_endpoint_pr_if interface:

<installation directory>/eda/sim_lib/altera_lnsim.sv

The simulation state of the SDM simulation model represents the PR_EVENT_TYPE enumeration state of the SDM. The config_stream_endpoint_pr_test_pkg SystemVerilog package defines these enumerations. These states represent the different allowed states for the SDM. The following are SDM enumeration definitions:

package config_stream_endpoint_pr_test_pkg;
    typedef enum logic [31:0] {
        NONE,
        IDLE,
        PR_REQUEST,
        PR_IN_PROGRESS,
        PR_COMPLETE_SUCCESS,
        PR_COMPLETE_ERROR,
        PR_INCOMPLETE_SYS_BUSY,
        PR_INCOMPLETE_BAD_DATA
    } PR_EVENT_TYPE;