Visible to Intel only — GUID: mjw1550626050140
Ixiasoft
1. Intel Agilex® 7 F-Series and I-Series General-Purpose I/O Overview
2. Intel Agilex® 7 F-Series and I-Series GPIO Banks
3. Intel Agilex® 7 F-Series and I-Series HPS I/O Banks
4. Intel Agilex® 7 F-Series and I-Series SDM I/O Banks
5. Intel Agilex® 7 F-Series and I-Series I/O Troubleshooting Guidelines
6. Intel Agilex® 7 F-Series and I-Series General-Purpose I/O IPs
7. Programmable I/O Features Description
8. Documentation Related to the Intel Agilex® 7 General-Purpose I/O User Guide: F-Series and I-Series
9. Document Revision History for the Intel Agilex® 7 General-Purpose I/O User Guide: F-Series and I-Series
2.5.1. VREF Sources and VREF Pins
2.5.2. I/O Standards Implementation Based on VCCIO_PIO Voltages
2.5.3. OCT Calibration Block Requirement
2.5.4. I/O Pins Placement Requirements
2.5.5. I/O Standard Selection and I/O Bank Supply Compatibility Check
2.5.6. Simultaneous Switching Noise
2.5.7. Special Pins Requirement
2.5.8. External Memory Interface Pin Placement Requirements
2.5.9. HPS Shared I/O Requirements
2.5.10. Clocking Requirements
2.5.11. SDM Shared I/O Requirements
2.5.12. Unused Pins
2.5.13. Voltage Setting for Unused GPIO Banks
2.5.14. GPIO Pins During Power Sequencing
2.5.15. Drive Strength Requirement for GPIO Input Pins
2.5.16. Maximum DC Current Restrictions
2.5.17. 1.2 V I/O Interface Voltage Level Compatibility
2.5.18. GPIO Pins for the Avalon® Streaming Interface Configuration Scheme
2.5.19. Maximum True Differential Signaling Receiver Pairs Per I/O Lane
6.1.1. Release Information for GPIO Intel® FPGA IP
6.1.2. Generating the GPIO Intel® FPGA IP
6.1.3. GPIO Intel® FPGA IP Parameter Settings
6.1.4. GPIO Intel® FPGA IP Interface Signals
6.1.5. GPIO Intel® FPGA IP Architecture
6.1.6. Verifying Resource Utilization and Design Performance
6.1.7. GPIO Intel® FPGA IP Timing
6.1.8. GPIO Intel® FPGA IP Design Examples
Visible to Intel only — GUID: mjw1550626050140
Ixiasoft
2.4.1. Single-Ended I/O Termination in F-Series and I-Series Devices
F-Series and I-Series devices support on-chip termination for single-ended I/O standards. OCT maintains signal quality, saves board space, and reduces external component costs.
Figure 6. RS and RT OCTThis figure shows the single-ended termination schemes supported in F-Series and I-Series devices. RT1 and RT2 are dynamic parallel terminations that switch on only when the device is receiving. In bidirectional applications, RT1 and RT2 automatically switch on when the device is receiving and switch off when the device is driving.