Mailbox Client Intel® FPGA IP User Guide

Download PDF
ID 683290
Date 4/04/2022
Public

A newer version of this document is available. Customers should click here to go to the newest version.

Document Table of Contents
Document Table of Contents x
1. Mailbox Client Intel FPGA IP User Guide 2. Appendix: CONFIG_STATUS and RSU_STATUS Error Code Descriptions
1. Mailbox Client Intel FPGA IP User Guide x
1.1. Device Family Support 1.2. Parameters 1.3. Mailbox Client Intel FPGA Core Interface Signals 1.4. Mailbox Client Intel FPGA IP Avalon® MM Memory Map 1.5. Commands and Responses 1.6. Specifying the Command and Response FIFO Depths 1.7. Enabling Cryptographic Services 1.8. Using the Mailbox Client Intel FPGA IP 1.9. Mailbox Client Intel FPGA IP Core Use Case Examples 1.10. Nios® II HAL Driver 1.11. Mailbox Client Intel FPGA IP User Guide Archives 1.12. Document Revision History for the Mailbox Client Intel FPGA IP User Guide
1.3. Mailbox Client Intel FPGA Core Interface Signals x
1.3.1. Clock and Reset Interfaces 1.3.2. Avalon® Memory-Mapped Interface 1.3.3. AXI Manager Interface
1.4. Mailbox Client Intel FPGA IP Avalon® MM Memory Map x
1.4.1. Interrupt Enable Register 1.4.2. Interrupt Status Register 1.4.3. Timer Registers
1.5. Commands and Responses x
1.5.1. Operation Commands 1.5.2. Error Code Responses 1.5.3. Error Code Recovery
1.10. Nios® II HAL Driver x
1.10.1. Driver API
1. Mailbox Client Intel FPGA IP User Guide
2. Appendix: CONFIG_STATUS and RSU_STATUS Error Code Descriptions

1.9. Mailbox Client Intel FPGA IP Core Use Case Examples

The Mailbox Client Intel FPGA IP is an Avalon® MM slave component that must connect to an Avalon® MM master. The simplest Avalon® MM master is the JTAG-to-Avalon Master.

The rsu1.tcl script provides examples to perform all the available command functions. You can run the functions available in the rsu1.tcl script via System Console of the Intel® Quartus® Prime software.

The following example shows how to access the quad SPI flash memory. Follow this sequence to prevent errors. Refer to Table 11 for more information about these commands.
  1. QSPI_OPEN
  2. QSPI_SET_CS
  3. Any of the following quad SPI operations:
    • QSPI_READ
    • QSPI_WRITE
    • QSPI_ERASE
    • QSPI_READ_DEVICE_REG
    • QSPI_WRITE_DEVICE_REG
    • QSPI_SEND_DEVICE_OP
  4. QSPI_CLOSE
Related Information
Level Two Title