Visible to Intel only — GUID: hak1520309223635
Ixiasoft
1. About the 25G Ethernet Intel FPGA IP
2. Getting Started
3. 25G Ethernet Intel FPGA IP Parameters
4. Functional Description
5. Reset
6. Interfaces and Signal Descriptions
7. Control, Status, and Statistics Register Descriptions
8. Debugging the Link
9. 25G Ethernet Stratix® 10 Intel® FPGA IP User Guide Archives
10. Document Revision History for the 25G Ethernet Stratix® 10 Intel® FPGA IP User Guide
6.1. TX MAC Interface to User Logic
6.2. RX MAC Interface to User Logic
6.3. Transceivers
6.4. Transceiver Reconfiguration Signals
6.5. Avalon® Memory-Mapped Management Interface
6.6. PHY Interface Signals
6.7. 1588 PTP Interface Signals
6.8. Miscellaneous Status and Debug Signals
6.9. Reset Signals
Visible to Intel only — GUID: hak1520309223635
Ixiasoft
2.2. Specifying the Stratix® 10 IP Core Parameters and Options
The 25G Ethernet Intel FPGA IP parameter editor allows you to quickly configure your custom IP variation. Use the following steps to specify IP core options and parameters in the Quartus® Prime Pro Edition software.
- In the Quartus® Prime Pro Edition, click File > New Project Wizard to create a new Quartus Prime project, or File > Open Project to open an existing Quartus Prime project. The wizard prompts you to specify a device.
- In the IP Catalog (Tools > IP Catalog), locate and double-click the name of the IP core to customize. The New IP Variation window appears.
- In the New IP Variation dialog box, specify a top-level name for your custom IP variation. The parameter editor saves the IP variation settings in a file named <your_ip> .ip.
- Click Create. The parameter editor appears.
- On the IP tab, specify the parameters for your IP core variation. Refer to 25G Ethernet Intel FPGA IP Parameters for information about specific IP core parameters.
- Optionally, to generate a simulation testbench or compilation and hardware design example, follow the instructions in the 25G Ethernet Stratix® 10 FPGA IP Design Example User Guide.
- Click Generate HDL. The Generation dialog box appears.
- Specify output file generation options, and then click Generate. The IP variation files generate according to your specifications.
- Click Finish. The parameter editor adds the top-level .ip file to the current project automatically. If you are prompted to manually add the .ip file to the project, click Project > Add/Remove Files in Project to add the file.
- After generating and instantiating your IP variation, make appropriate pin assignments to connect ports.
Related Information