25G Ethernet Stratix® 10 Intel® FPGA IP User Guide

ID 683154
Date 6/20/2024
Public
Document Table of Contents

6.9. Reset Signals

The IP core has three external hard reset inputs. These resets are asynchronous and are internally synchronized. Assert resets for ten cycles or until you observe the effect of their specific reset. Asserting the external hard reset csr_rst_n returns control and status registers to their original values. rx_pcs_ready and tx_lanes_stable are asserted when the IP core has exited reset successfully.
Table 23.   Reset Signals

Signal

Direction

Description

tx_rst_n Input Active low hard reset signal. Resets the TX interface, including the TX PCS and TX MAC. This reset leads to the deassertion of the tx_lanes_stable output signal.
rx_rst_n Input

Active low hard reset signal. Resets the RX interface, including the RX PCS and RX MAC. This reset leads to the deassertion of the rx_pcs_ready output signal.

csr_rst_n Input

Active low hard global reset. Resets the full IP core. Resets the TX MAC, RX MAC, TX PCS, RX PCS, adapters, transceivers, and control, status, and statistic registers. This reset leads to the deassertion of the tx_lanes_stable and rx_pcs_ready output signals.

channel_reset Input This port is only present if the Enable 10G/25G Dynamic Rate Switching parameter is enabled. Before initiating reconfiguration between speeds, assert this signal to hold the TX or RX data paths in reset.