Visible to Intel only — GUID: kvr1602192154556
Ixiasoft
1.1.2.1. Specify Instance-Specific Constraints in Assignment Editor
1.1.2.2. Specifying Multi-Dimensional Bus Constraints
1.1.2.3. Specify I/O Constraints in Pin Planner
1.1.2.4. Plan Interface Constraints in Interface Planner and Tile Interface Planner
1.1.2.5. Adjust Constraints with the Chip Planner
1.1.2.6. Constraining Designs with the Design Partition Planner
Visible to Intel only — GUID: kvr1602192154556
Ixiasoft
2.2.2.2. Step 2: Initialize Tile Interface Planner
When you launch Tile Interface Planner, the tool initializes the placement legality engine and loads component IP and target device data extracted by Design Analysis. Tile Interface Planner then displays the component IP information in the Design Tree view and enables the Flow control.
Tile Interface Planner Flow Control
To initialize Tile Interface Planner:
- Run the Design Analysis stage of the Compiler, as Step 1: Instantiate IP and Run Design Analysis describes.
- When Design Analysis is complete, launch Tile Interface Planner by clicking the Tile Interface Planner icon in the Compilation Dashboard, the main toolbar, or by clicking Tools > Tile Interface Planner.
Figure 27. Launching Tile Interface Planner
Tile Interface Planner launches and initializes with the legality engine and the component IP and target device data that Design Analysis extracts.
- Load existing project assignments, as Step 3: Update Plan with Project Assignments describes.