Visible to Intel only — GUID: ude1704167206766
Ixiasoft
1. About the Low Latency 40G Ethernet Intel® FPGA IP
2. Low Latency 40G Ethernet Intel® FPGA IP Parameters
3. Getting Started
4. Functional Description
5. Clocking and Reset Requirements
6. Interfaces and Signal Descriptions
7. Control, Status, and Statistics Register Descriptions
8. Comparison Between Various Low Latency 40G Ethernet Intel® FPGA IPs
9. Document Revision History for the Low Latency 40G Ethernet Intel® FPGA IP User Guide: Agilex™ 5 FPGAs and SoCs
6.1. TX MAC Interface to User Logic
6.2. RX MAC Interface to User Logic
6.3. TX PCS Interface to User Logic
6.4. RX PCS Interface to User Logic
6.5. GTS Transceivers Signals
6.6. GTS Transceiver Reconfiguration Signals
6.7. Avalon® Memory-Mapped Management Interface
6.8. Miscellaneous Status and Debug Signals
6.9. Reset Signals
6.10. Clocks
6.11. Flow Control Interface
6.12. GTS Reset Sequencer Intel® FPGA IP
Visible to Intel only — GUID: ude1704167206766
Ixiasoft
4.3.1.2. Frame Padding
When the length of the client frame is less than 64 bytes, the TX MAC module inserts pad bytes (0x00) after the payload to create a frame length equal to the minimum size of 64 bytes (including CRC).
Note: The IP does not support the length of client frame less than 9 bytes and filters it out if MAC TX receives such a short frame. That is, if l2_tx_starofpacket and l2_tx_endofpacket are asserted at the same cycle, these are filtered out regardless of preamble pass-through mode.