Visible to Intel only — GUID: xnv1564730934302
Ixiasoft
1. Agilex™ 7 FPGA F-Series and I-Series Clocking and PLL Overview
2. F-Series and I-Series Clocking and PLL Architecture and Features
3. F-Series and I-Series Clocking and PLL Design Considerations
4. Clock Control Intel® FPGA IP Core
5. IOPLL Intel® FPGA IP Core
6. IOPLL Reconfig Intel® FPGA IP Core
7. Agilex™ 7 Clocking and PLL User Guide: F-Series and I-Series Archives
8. Document Revision History for the Agilex™ 7 Clocking and PLL User Guide: F-Series and I-Series
2.2.1. PLL Features
2.2.2. PLL Usage
2.2.3. PLL Locations
2.2.4. PLL Architecture
2.2.5. PLL Control Signals
2.2.6. PLL Feedback Modes
2.2.7. Clock Multiplication and Division
2.2.8. Programmable Phase Shift
2.2.9. Programmable Duty Cycle
2.2.10. PLL Cascading
2.2.11. PLL Input Clock Switchover
2.2.12. PLL Reconfiguration and Dynamic Phase Shift
2.2.13. PLL Calibration
3.1. Guidelines: Clock Switchover
3.2. Guidelines: Timing Closure
3.3. Guidelines: Resetting the PLL
3.4. Guidelines: Configuration Constraints
3.5. Guidelines: I/O PLL Reconfiguration
3.6. Clocking Constraints
3.7. IP Core Constraints
3.8. Guideline: Achieving 5% Duty Cycle for fOUT_EXT ≥ 300 MHz Using tx_outclk Port from LVDS SERDES Intel® FPGA IP
6.1. Release Information for IOPLL Reconfig Intel® FPGA IP
6.2. Implementing I/O PLL Reconfiguration in the IOPLL Reconfig IP Core
6.3. IOPLL Reconfig IP Core Reconfiguration Modes
6.4. Avalon® Memory-Mapped Interface Ports in the IOPLL Reconfig IP Core
6.5. Address Bus and Data Bus Settings
6.6. Design Example
Visible to Intel only — GUID: xnv1564730934302
Ixiasoft
6.3.4. Dynamic Phase Shift Reconfiguration
The dynamic phase shifts reconfiguration can determine the number of shifts, the direction of the phase shift and the output clock to be shifted.
To perform dynamic phase shift reconfiguration through the IOPLL Reconfig IP core, follow these steps:
- Set mgmt_address[9:8] to 2’b11 to select dynamic phase shift reconfiguration mode.
- set mgmt_writedata[7:0] to indicate the desired number of phase shift, the direction of phase shift, and the desired counter to be shifted.
- To start the dynamic phase shift reconfiguration on the I/O PLL, assert the mgmt_write signal for one mgmt_clk cycle. This signal is the equivalent of the phase_en signal on the I/O PLL.
- After the dynamic phase shift is complete, the mgmt_waitrequest signal is de-asserted.