AN 717: Nios II Gen2 Hardware Development Tutorial

Download PDF
ID 683615
Date 9/22/2014
Public
Document Table of Contents
Document Table of Contents x
1. Hardware Development Tutorial
1. Hardware Development Tutorial x
1.1. Software and Hardware Requirements 1.2. 1.3. Design Example 1.4. System Development Flow 1.5. Creating the Design Example 1.6. Document Revision History
1.4. System Development Flow x
1.4.1. Analyzing System Requirements 1.4.2. Defining and Generating the System in 1.4.3. Integrating the System into the Project 1.4.4. Developing Software with the Software Build Tools for Eclipse 1.4.5. Running and Debugging Software on the Target Board 1.4.6. Varying the Development Flow
1.5. Creating the Design Example x
1.5.1. Install the Design Files 1.5.2. Analyze System Requirements 1.5.3. Start the Software and Open the Example Project 1.5.4. Create a New System 1.5.5. Define the System in 1.5.6. Integrate the System into the Project 1.5.7. Download the Hardware Design to the Target FPGA 1.5.8. Develop Software Using the SBT for Eclipse 1.5.9. Run the Program on Target Hardware
1.5.5. Define the System in x
1.5.5.1. Specify Target FPGA and Clock Settings 1.5.5.2. Add the On-Chip Memory 1.5.5.3. Add the Processor Core 1.5.5.4. Add the JTAG UART 1.5.5.5. Add the Interval Timer 1.5.5.6. Add the System ID Peripheral 1.5.5.7. Add the PIO 1.5.5.8. Specify Base Addresses and Interrupt Request Priorities 1.5.5.9. Generate the System
1.5.6. Integrate the System into the Project x
1.5.6.1. Instantiate the System Module in the Project 1.5.6.2. Add IP Variation File 1.5.6.3. Assign FPGA Device 1.5.6.4. Assign FPGA Pin Locations 1.5.6.5. Set Timing 1.5.6.6. Compile the Project and Verify Timing
1.5.8. Develop Software Using the SBT for Eclipse x
1.5.8.1. Create a New Application and BSP from Template 1.5.8.2. Compile the Project
1. Hardware Development Tutorial

1.5.5.9. Generate the Qsys System

To generate the Qsys system, perform the following steps:

  1. Click the Generation tab.
  2. Select None in both the Create simulation model and Create testbench Qsys system lists.
    Because this tutorial does not cover the hardware simulation flow, you can select these settings to shorten generation time.
  3. Click Generate. Click Yes when the Save changes? dialog box appears.
  4. Type first_nios2_system in the File name box and click Save.
    The Generate dialog box appears and system generation process begins. The generation process can take several minutes. When generation completes, Qsys will prompt: Create HDL design files for synthesis.
  5. Click Close to close the dialog box.
  6. On the File menu, click Exit to close Qsys and return to the Quartus II software.
You are ready to integrate the system into the Quartus II hardware project and use the Nios II SBT for Eclipse to develop software.
Level Two Title