Intel® MAX® 10 FPGA 10M50 Evaluation Kit User Guide

Download PDF
ID 683447
Date 1/11/2024
Public
Document Table of Contents
Document Table of Contents x
1. Intel® MAX® 10 FPGA 10M50 Evaluation Kit Overview 2. Getting Started 3. Board Components A. Additional Information
1. Intel® MAX® 10 FPGA 10M50 Evaluation Kit Overview x
1.1. Board Component Blocks 1.2. Supported Items Not Included with the Kit
2. Getting Started x
2.1. Powering the Kit 2.2. Installing the Intel® FPGA Download Cable II Driver 2.3. Handling the Kit 2.4. Factory Default Switch and Jumper Settings
3. Board Components x
3.1. Board Overview 3.2. Featured Device: Intel® MAX® 10 FPGA 3.3. Configuration 3.4. Status Elements 3.5. Setup Elements 3.6. General User Input/Output 3.7. Clock Circuitry 3.8. Components and Interfaces
3.3. Configuration x
3.3.1. Using the Intel® Quartus® Prime Programmer 3.3.2. Selecting the Internal Configuration Scheme
3.7. Clock Circuitry x
3.7.1. On-Board Oscillators 3.7.2. Off-Board Clock Input/Output 3.7.3. Clock Control GUI
3.7.3. Clock Control GUI x
3.7.3.1. The Clock Control
3.8. Components and Interfaces x
3.8.1. HDMI Video Output 3.8.2. Pmod Connectors 3.8.3. Memory 3.8.4. Flash 3.8.5. MIPI CSI-2 Transmitter 3.8.6. MIPI CSI-2 Receiver 3.8.7. Power Supply
3.8.3. Memory x
3.8.3.1. LPDDR2
3.8.7. Power Supply x
3.8.7.1. Power Options 3.8.7.2. Power-Up Sequence
A. Additional Information x
A.1. Document Revision History for the Intel® MAX® 10 FPGA 10M50 Evaluation Kit User Guide A.2. Safety and Regulatory Information A.3. Compliance Information
A.2. Safety and Regulatory Information x
A.2.1. Safety Warnings A.2.2. Safety Cautions
1. Intel® MAX® 10 FPGA 10M50 Evaluation Kit Overview
2. Getting Started
3. Board Components
A. Additional Information

3.8.7.1. Power Options

You can apply power to the Intel® MAX® 10 FPGA Evaluation Kit by plugging in either 5V DC power adapter to wall jack, or USB cable to your PC. For low-power design, USB cable connection is suggested, and it can easily provide both power and on-board Intel® FPGA Download Cable connection. For high-power design, DC adapter solution is preferred to ensure device performance.

The board includes one Jumper (J11) for power option selection. When use DC power adapter, J11 needs to be placed at Position 1 and 2; while for using USB power, J11 needs to be placed at Position 2 and 3. The USB power is default power setup.

Resistors (R292 and R293) can be populated and used in place of the jumper if you want to hard wire the power option.

When powered correctly, D9, D10 and D11 will light.

CAUTION:
Resistors R292 and R293 are designed for hard wiring the power selection. J11 must not be used when either R292 or R293 is populated.
Level Two Title