Board Management Controller User Guide: Intel FPGA Programmable Acceleration Card N3000-N

Download PDF
ID 683186
Date 9/08/2020
Public
Document Table of Contents
Document Table of Contents x
1. Introduction 2. Board Monitoring through PLDM over MCTP SMBus 3. Board Monitoring through I2C SMBus 4. EEPROM Data Format 5. Document Revision History for Board Management Controller User Guide: Intel FPGA Programmable Acceleration Card N3000-N A. Example PLDM Command and Response Messages
1. Introduction x
1.1. About this Document 1.2. Overview 1.3. Root of Trust (RoT) 1.4. Secure Remote System Update 1.5. Power Sequence Management 1.6. Board Monitoring Through Sensors
2. Board Monitoring through PLDM over MCTP SMBus x
2.1. SMBus Interface Speed 2.2. MCTP Packetization Support 2.3. Supported Command Sets 2.4. PLDM Topology and Hierarchy
4. EEPROM Data Format x
4.1. MAC EEPROM 4.2. Field Replaceable Unit Identification (FRUID) EEPROM Access
1. Introduction
2. Board Monitoring through PLDM over MCTP SMBus
3. Board Monitoring through I2C SMBus
4. EEPROM Data Format
5. Document Revision History for Board Management Controller User Guide: Intel FPGA Programmable Acceleration Card N3000-N
A. Example PLDM Command and Response Messages

1.5. Power Sequence Management

The BMC Power sequencer state machine manages the Intel® FPGA PAC N3000-N power-on and power-off sequences. The Intel® MAX® 10 power-up flow covers the entire process including Intel® MAX® 10 boot-up, Nios® boot-up, and power sequence management for FPGA configuration. The host must check the build versions of both the Intel® MAX® 10 and FPGA, as well as the Nios® status after every power-cycle, and take corresponding actions in case the Intel® FPGA PAC N3000-N runs into corner cases such as an Intel® MAX® 10 or FPGA factory build load failure or Nios® boot up failure. The BMC protects the Intel® FPGA PAC N3000-N by shutting down power to the card under the following conditions:
  • 12 V Auxiliary or PCIe edge supply voltage is below 10.46 V
  • FPGA core temperature reaches 100°C
  • Board temperature reaches 100°C
Note: The LEDs blink yellow when the Intel® FPGA PAC N3000-N shuts down.
Level Two Title