F-Tile Ethernet Intel® FPGA Hard IP User Guide

ID 683023
Date 6/26/2023
Public

A newer version of this document is available. Customers should click here to go to the newest version.

Document Table of Contents

9.2.2. Clocks, Reset, and Interface Ports

Table 78.  Clock Ports
Name Description
i_sys_clk Clock source to drive TX deskew pulse generation logic. Must be connected to the F-Tile Reference and System PLL Clock Intel® FPGA IP clock source (o_clk_pll).

The clock frequency is equivalent to a half of a system PLL frequency, specified by the System PLL frequency parameter. The minimal frequency is 402.83 MHz.

i_reconfig_clk Reconfiguration clock for Avalon® memory-mapped interface.
o_clk_pll

Clock derived from the F-Tile Reference and System PLL Clock Intel® FPGA IP associated with the Ethernet IP port. The o_clk_pll frequency is equal to PLL frequency divided by 2.

When PTP is enabled, the PTP tile adapter's o_clk_pll is a clock input to the i_clk_tx, i_clk_rx Ethernet clocks, and i_clk_pll for Asynchronous mode, for all Ethernet modes.

Table 79.  Reset Ports
Name Description
i_rst_n Active-low reset signal synchronous to the i_sys_clk clock.

Intel recommends connecting the reset to the synchronized version of the o_tx_pll_locked output signal of an active Ethernet IP port.

You must assert this reset when the i_sys_clk clock is not stable.

i_reconfig_reset

Active-high reconfiguration reset signal. Resets the entire reconfiguration clock domain.

You must assert this reset after power-on or during configuration. The i_reconfig_clk must be stable before deasserting this reset.

Table 80.  Interface Ports
Name Description
ptp_link Represents a logical connection between PTP Tile Adapter and the Ethernet IP with enabled PTP.

During Support-Logic Generation, if the ptp_link is connected, the IP flow generates a PTP signal bus between the PTP Tile Adapter and one or more Ethernet IP with enabled PTP option within the same F-tile design.