Intel® MAX® 10 FPGA (10M08S, 144-EQFP) Evaluation Kit User Guide

Download PDF
ID 812857
Date 1/08/2023
Public
Document Table of Contents
Document Table of Contents x
1. Overview 2. Getting Started 3. Board Components 4. Document Revision History for Intel® MAX® 10 FPGA (10M08S, 144-EQFP) Evaluation Kit User Guide A. Additional Information
1. Overview x
1.1. Board Component Blocks 1.2. Supported Items Not Included with the Kit
2. Getting Started x
2.1. Powering the Kit 2.2. Installing the Intel® FPGA Download Cable Driver 2.3. Handling the Kit 2.4. Factory Default Switch and Jumper Settings
3. Board Components x
3.1. Board Overview 3.2. Featured Device: Intel® MAX® 10 FPGA 3.3. Configuration 3.4. Clock Circuitry 3.5. Arduino Connectors 3.6. General User Input/Output 3.7. Power Supply
3.3. Configuration x
3.3.1. FPGA Programming over External Intel® FPGA Download Cable 3.3.2. Configuring the FPGA Using the Intel® Quartus® Prime Programmer 3.3.3. Selecting Internal Configuration Scheme 3.3.4. Generating a .pof File with ICB Settings 3.3.5. Programming Internal Flash Memory
3.4. Clock Circuitry x
3.4.1. General-Purpose Clock
3.6. General User Input/Output x
3.6.1. User-Defined DIP Switch 3.6.2. User-Defined LEDs
3.7. Power Supply x
3.7.1. Power Measurement 3.7.2. Power Distribution System 3.7.3. Temperature Sense
A. Additional Information x
A.1. Safety and Regulatory Information A.2. Compliance Information
A.1. Safety and Regulatory Information x
A.1.1. Safety Warnings Power Supply Hazardous Voltage Power Connect and Disconnect System Grounding (Earthing) Power Cord Requirements Lightning/Electrical Storm Risk of Fire A.1.2. Safety Cautions
1. Overview
2. Getting Started
3. Board Components
4. Document Revision History for Intel® MAX® 10 FPGA (10M08S, 144-EQFP) Evaluation Kit User Guide
A. Additional Information

A.1.1. Safety Warnings

Power Supply Hazardous Voltage

AC mains voltages are present within the power supply assembly. No user serviceable parts are present inside the power supply.

Power Connect and Disconnect

The AC power supply cord is the primary disconnect device from mains (AC power) and used to remove all DC power from the board/system. The socket outlet must be installed near the equipment and must be readily accessible.

System Grounding (Earthing)

To avoid shock, you must ensure that the power cord is connected to a properly wired and grounded receptacle. Ensure that any equipment to which this product is attached to is also connected to properly wired and grounded receptacles.

Power Cord Requirements

The plug on the power cord must be a grounding-type male plug designed for use in your region. It must have certification marks showing certification by an agency in your region. The connector that plugs into the appliance inlet of the power supply must be an IEC 320, sheet C13, female connector. If the power cord supplied with the system does not meet requirements for use in your region, discard the cord, and do not use it with adapters. Use only certified power supply cord with appropriate gauge, designed for use in your region.

Lightning/Electrical Storm

Do not connect/disconnect any cables or perform installation/maintenance of this product during an electrical storm.

Risk of Fire

To reduce the risk of fire, keep all flammable materials a safe distance away from the boards and power supply. You must configure the development kit on a flame retardant surface.

Level Two Title